Experimental and theoretical study of 90 Sr/ 90 Y-n-Si/ZnO betavoltaic battery and theoretical prediction of homojunction betavoltaic cells performance
Zohreh Movahedian,Hossein Tavakoli-Anbaran
DOI: https://doi.org/10.1016/j.mssp.2024.109059
IF: 4.1
2024-11-05
Materials Science in Semiconductor Processing
Abstract:Today, betavoltaic batteries has been considered due to their high energy density and long life for operating electrical systems in inaccessible and hostile environments. Conventional electrochemical batteries, despite their widespread use in electronic devices, have a limited lifetime and tend to degrade in extreme environmental conditions. The current paper pursues three goals. The first goal is to the experimental and theoretical investigation of a n-Si/ZnO heterojunction betavoltaic battery based on 90 Sr/ 90 Y source. The second goal is to optimize ZnO, SnO 2 , BN, and diamond homojunction betavoltaic cells in two planar and cubical models by Monte Carlo simulation (MCNP code). The third goal is to present a new approach for estimating the standard error in calculating the parameters of betavoltaic batteries. In order to fabrication of a n-Si/ZnO heterojunction, the ZnO nanospheres were placed on the n-Si (100) substrate using chemical bath deposition (CBD) technology. The Al and Au electrodes were deposited on the formed sample. Then this sample was exposed to the radiation of an external 90 Sr/ 90 Y source with an activity of 12.8 mCi. The experimental values obtained for the short circuit current (I sc ), open circuit voltage (V oc ), efficiency (η), and maximum output power (P max ) were 0.047 μA, 0.015 V, 3.4 × 10 −4 percent, and 0.141 nW, respectively. To compare with the experiment, we investigated the n-Si/ZnO betavoltaic cell by MCNP code. In the simulation, the beta spectrum of the 90 Sr/ 90 Y source was considered. The calculated theoretical values for I sc , V oc , η, and P max were 0.063 μA, 0.020 V, 6.4 × 10 −4 percent, and 0.265 nW, respectively. The experimental results show that the simulation results can be valid. In the optimization of ZnO, SnO 2 , BN, and diamond homojunction betavoltaic cells in two planar and cubical models by MCNP code, it was found that the I sc , V oc , η, and P max of the cubical model are better compared to the planar model. In the cubical model, P max of ZnO, SnO 2 , BN, and diamond betavoltaic batteries is 2633.34 nW ± 0.16 %, 1670.49 nW ± 0.15 %, 198.20 nW ± 0.17 %, and 1315.24 nW ± 0.15 %, respectively. In other words, P max of the ZnO betavoltaic battery is about 58 %, 1229 %, and 100 % more than P max of SnO 2 , BN, and diamond betavoltaic batteries, respectively. P max of the SnO 2 betavoltaic battery is about 743 % and 27 % more than P max of BN and diamond betavoltaic batteries, respectively. The results show that ZnO and SnO 2 betavoltaic batteries can perform better compared to BN and diamond betavoltaic batteries. Also, their growth process is less expensive compared to BN and diamond.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied