Abstract:Based on the fluid volume approach, a transient numerical model for the condensation heat transfer and flow features in a microchannel is proposed. The flow condensation of R32 in a circular microtube with 0.1 mm diameter was studied. Four typical flow patterns, annular, injection flow, slug flow and bubbly flow are simulated along a two-dimension calculational domain successively. The numerical mode is verified by the experiments from the literature. The numerical results discern that the increase of mass flux, wall temperature and saturation temperature affect the detachment point of vapor slug further toward the outlet with higher occurrence frequency, which can be attributed to the higher Weber number and Capillary number of tail vapor core respectively. The local heat flux and wall shear stress will decrease along the flow direction overall, and tend to be constant in the single phase liquid area. However, there exit some rebounds and oscillations of the local heat flux and wall shear stress during injection and slug flow. The transient oscillations of wall shear stress can induce fluctuations and even waves in the annular flow upstream, which can be concluded as "surface tension force affecting upstream", is proposed based on the minimum potential energy theory. This mechanism could be a supplement for the traditional theory of "flow pattern transition at high mass flux being induced by fluctuations which grow up while flowing downstream". (C) 2018 Elsevier Ltd. All rights reserved.

Numerical Simulation of Multi-Pass Parallel Flow Condensers with Liquid-Vapor Separation

Numerical Simulation and Experimental Study of Capillary Tubes

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Physical Model and Numerical Simulation Approach of Steam Flow and Heat Transfer of Pannier-arrangement Condensers

Numerical simulation on the header-orifice structure-based liquid-vapor separator used in liquid-separation condenser

Numerical simulation of condensation heat transfer and pressure-drop performance of R22 and R407C in horizontal microfin tube

Modeling for Multi-Pass Parallel Flow Condenser with the Effect of Refrigerant Mal-Distribution

Evaluation of microchannel condenser characteristics by numerical simulation

Numerical simulation of refrigerant flow arrangement in condensers(2): numerical simulation results and analysis

An experimentally validated model for microchannel condensers with separation circuitry

Simulation Model for Micro-channel Parallel Flow Condenser Using R1234yf As Working Fluid

Simulation of Condensation Flow in A Rectangular Microchannel

Optimization of a microchannel condenser with separation circuitry

Prediction and Verification of the Thermodynamic Performance of Vapor–liquid Separation Condenser

A Multi-Fluid Model for Non-Equilibrium Condensation in Gaseous Carrier Flows

Modeling and experimental study of air-cooled finned-tube condenser using coupled distribution parameter method and air-side temperature distribution

Numerical Simulation and Analysis of Micro-channel Condenser

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Numerical Simulation Of Wet Steam Condensing Flow Based On A Two-Fluid Model

Explorations of multi‐pass‐orifice header in the liquid‐separation condenser by using CFD simulation

Numerical Studies on Two-Phase Flow in Cryogenic Radial-Inflow Turbo-Expander Using Varying Condensation Models