Abstract:An ultra-low frequency vibrational noise isolation apparatus from external vibration can be a critical factor in many fields such as precision measurement, high-technology manufacturing, scientific instruments, and gravitational wave detection. To increase the accuracies of these experiments, well performed vibration isolation technology is required. Until recently the cold atom gravimeter has played a crucial role in measuring the acceleration due to gravity and earth gravity gradient. The vibration isolation is one of the key techniques in the cold atom gravimeter. To reduce the vibrational noise caused by the reflecting mirror of Raman beams in the cold atom gravimeter, a compact active low-frequency vibration isolation system based on sliding-mode robust control is designed and demonstrated. The sliding-mode robust control active vibration isolation method is used to solve the vibration problem of Raman mirror in the cold atomic gravimeter. The purpose of vibration control is that the controller enables the system to be at zero state as the system states are away from the equilibrium due to vibration disturbance. In this system, the mechanical setup is based on a commercial passive isolation platform which only plays a role at higher frequency. A sliding-mode robust control subsystem is used to process and feed back the vibration measured by a seismometer which can measure the velocity of the ground vibration. A voice coil actuator is used to control and cancel the motion of a passive vibration isolation platform. The simulation and experiment results of vibration isolation platform show, on the one hand, that the vibration noise power spectral density decreases by up to 99.9%, and that the phase noise in cold atom interferometry produced by vibration decreases by up to nearly 85.3% compared with the results of the passive vibration isolation platform. On the other hand, compared with the lead-lag control method, the vibration noise power spectral density decreases by up to 83.3% and the phase noise in cold atom interferometry produced by vibration decreases by nearly 40.2%. Therefore, the sliding-mode robust control has the advantages of less tuning parameters, strong anti-interference ability, and more obvious vibration isolating effect.

Vibration Compensation of an Atom Gravimeter

Vibration Compensating Beam Scanning Interferometer for Surface Measurement

A Vibration Compensation Method for Absolute Gravimeters

Exploration of Microgravity by Using the Cold Atom Interferometer in Deep Space Environment

Demonstration of an ultrahigh-sensitivity atom-interferometry absolute gravimeter

A portable atom gravimeter operating in noisy urban environments

Operating an atom interferometer beyond its linear range

Atomic gravimeter robust to environmental effects

A Mobile Three-Dimensional Active Vibration Isolator and Its Application to Cold Atom Interferometry

A Compact Atom Interferometer for Field Gravity Measurements

The investigation of a μGal-level cold atom gravimeter for field applications

High precision atom interferometer-based dynamic gravimeter measurement by eliminating the cross-coupling effect

Improved frequency shift compensation technique and pulse sequence for multi-loop atom interference experiments

Continuous Gravity Measurement with a Portable Atom Gravimeter

Ultra-low frequency active vibration control for cold atom gravimeter based on sliding-mode robust algorithm

Enhanced Readout from Spatial Interference Fringes in a Point-Source Cold Atom Inertial Sensor

High-Precision Atom Interferometer-Based Dynamic Gravimeter Measurement by Eliminating the Cross-Coupling Effect

Compact active vibration isolation and tilt stabilization for a portable high-precision atomic gravimeter

Quantum Gyroscope Based on an Atom Interferometer

Investigation of the thermal adaptability for a mobile cold atom gravimeter

An entanglement-enhanced atomic gravimeter