Abstract:An ultra-low frequency vibrational noise isolation apparatus from external vibration can be a critical factor in many fields such as precision measurement, high-technology manufacturing, scientific instruments, and gravitational wave detection. To increase the accuracies of these experiments, well performed vibration isolation technology is required. Until recently the cold atom gravimeter has played a crucial role in measuring the acceleration due to gravity and earth gravity gradient. The vibration isolation is one of the key techniques in the cold atom gravimeter. To reduce the vibrational noise caused by the reflecting mirror of Raman beams in the cold atom gravimeter, a compact active low-frequency vibration isolation system based on sliding-mode robust control is designed and demonstrated. The sliding-mode robust control active vibration isolation method is used to solve the vibration problem of Raman mirror in the cold atomic gravimeter. The purpose of vibration control is that the controller enables the system to be at zero state as the system states are away from the equilibrium due to vibration disturbance. In this system, the mechanical setup is based on a commercial passive isolation platform which only plays a role at higher frequency. A sliding-mode robust control subsystem is used to process and feed back the vibration measured by a seismometer which can measure the velocity of the ground vibration. A voice coil actuator is used to control and cancel the motion of a passive vibration isolation platform. The simulation and experiment results of vibration isolation platform show, on the one hand, that the vibration noise power spectral density decreases by up to 99.9%, and that the phase noise in cold atom interferometry produced by vibration decreases by up to nearly 85.3% compared with the results of the passive vibration isolation platform. On the other hand, compared with the lead-lag control method, the vibration noise power spectral density decreases by up to 83.3% and the phase noise in cold atom interferometry produced by vibration decreases by nearly 40.2%. Therefore, the sliding-mode robust control has the advantages of less tuning parameters, strong anti-interference ability, and more obvious vibration isolating effect.

Compact active vibration isolation and tilt stabilization for a portable high-precision atomic gravimeter

Atomic gravimeter robust to environmental effects

Accuracy Improvement of a Compact 85Rb Atom Gravimeter by Suppressing Laser Crosstalk and Light Shift

An Ultralow-Frequency Active Vertical Vibration Isolator with Geometric Antispring Structure for Absolute Gravimetry

A Compact Atom Interferometer for Field Gravity Measurements

Tilt Adjustment for a Portable Absolute Atomic Gravimeter*

Active Low-frequency Vertical Vibration Isolation System for Precision Measurements

Compact Cold Atom Gravimeters and Precise Gravity Measurement

Vibration Correction System Toward Dynamic Absolute Gravimetry

Ultra-low frequency active vibration control for cold atom gravimeter based on sliding-mode robust algorithm

Continuous Gravity Measurement with a Portable Atom Gravimeter

Adaptive Robust High-Precision Atomic Gravimetry

Portable Atomic Gravimeter Operating in Noisy Urban Environments

A Highly Stable and Sensitive MEMS-Based Gravimeter for Long-Term Earth Tides Observations

A portable atom gravimeter operating in noisy urban environments

Ultra-low Frequency Vertical Vibration Isolators for Absolute Gravimeters

Demonstration of an ultrahigh-sensitivity atom-interferometry absolute gravimeter

A vibrating beam MEMS accelerometer for gravity and seismic measurements

A compact laser system for a portable atom interferometry gravimeter

Correction of Vibration for Classical Free-Fall Gravimeters with Correlation-Analysis

Limits to the sensitivity of a low noise compact atomic gravimeter