Abstract:This article presents a wideband millimeter-wave power amplifier (PA) with a capacitive stability enhancement technique. It is composed of three differential cascode stages to attain high-power gain and large output power. To ensure the stabilization of the amplifier, a robust technique based on a series base capacitor is proposed and applied in each stage. Each capacitor creates a low-frequency zero to adjust the phase and amplitude responses of the differential cascode structure. As a result, the phase margin of the loop gain is increased remarkably. By adjusting the series base capacitors, the low-frequency zeros and gains of the three stages can be optimized. Therefore, the operating bandwidth is also extended. Meanwhile, a transformer-based four-path power combination network with a large current capacity is developed to further enlarge the output power. The circuit is demonstrated in a commercial 0.13 μm SiGe BiCMOS process. According to the measurement results, the PA obtains a saturated output power (P Sat ) of 18.5 dBm and output referred 1-dB compression point (OP 1dB ) of 16.32 dBm at 77 GHz. The tested small-signal gain is 26.7 dB at 77 GHz. Its 3 dB gain bandwidth is beyond 21.5 GHz, which ranges from 68.5 to 90 GHz. The P Sat variation is less than 0.57 dB at the frequency range from 70 to 85 GHz. The measurement also shows the PA with the proposed technique is unconditionally stable over the entire frequency band. The chip area is only 0.684 mm 2 .

A W-Band Transformer-Based Power Amplifier with Anti-Pair Capacitors in 0.13-Μm SiGe BiCMOS

Two-Way Current-Combining -Band Power Amplifier in 65-nm CMOS

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A 60GHz power amplifier with 12.1 dBm & P1dBCP in 0.18um SiGe BiCMOS process

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

A K-/Ka-Band 21.4 dBm Power Amplifier with Four-Way Twisted Combiner in <tex>$0.13\ \mu\mathrm{m}$</tex> SiGe BiCMOS

A K /Ka Band 21.4 dBm Power Amplifier with Four Way Twisted Combiner in SiGe BiCMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A G-band Cascode Power Amplifier in 0.13 Um SiGe BiCMOS Technology

A 21.08 dBm Q-band power amplifier in 90-nm CMOS process

A 140- and 220-Ghz Dual-Band Amplifier in 130-Nm SiGe BiCMOS Process

A V-Band Wideband Power Amplifier with High Gain in a 130 nm SiGe BiCMOS Process

A 160 GHz High Output Power and High Efficiency Power Amplifier in a 130-Nm SiGe BiCMOS Technology

A C Band Fully-integrated SiGe BiCMOS Power Amplifier

A two-way three-stage W-band power amplifier with series-parallel inductor-based T-type inter-stage matching network

A broadband, high isolation millimeter-wave CMOS power amplifier using a transformer and transmission line matching topology

45-Ghz and 60-Ghz 90 Nm CMOS Power Amplifiers with a Fully Symmetrical 8-Way Transformer Power Combiner.

A W-Band Power Amplifier Utilizing a Miniaturized Marchand Balun Combiner

A Fully-Integrated Dual Band CMOS Power Amplifier Based on an Active Matching Transformer