Abstract:Shrinkage cracks are some of the most common defects in timber structures obtained from woods with an uneven distribution of moisture content and are subject to external dynamic environmental changes. To accurately predict the changes in the moisture content of wood components at any time and position, this study first applied the principles of food drying and established a moisture field model for laminated wood based on the analogy between heat and humidity transfer. A model for predicting the moisture content of wood that considers time and spatial distribution was then proposed. Second, by collecting relevant experimental data and establishing a finite element analysis model, three moisture absorption conditions (0–9.95%, 0–13.65%, and 0–17.91%) and four desorption conditions (34–5.5%, 28–8.3%, 31–11.8%, and 25.5–15.9%) were analyzed. In the moisture absorption comparison, the time needed to reach 95% equilibrium moisture content was 2.43 days, 4.07 days, and 6.32 days. The rate at which the internal components reached equilibrium moisture content exceeded 10 days. The temporal and spatial distribution of wood moisture content revealed the correctness of the proposed wood moisture field model. Finally, the moisture content prediction model was applied in the order of characteristic equation solutions, moisture content gradient difference, and laminated wood size. The results revealed that the established humidity field model can predict the wood moisture content and how it changes over time and in space. Notably, 1–2 orders for the solution of the characteristic equation are recommended when applying the prediction model. The greater the difference in moisture content, the faster the equilibrium moisture content is reached. The moisture content varies greatly based on the component size and position. Notably, the influence of moisture gradient and wood size on the average wood moisture content cannot be ignored.

Experimental and Numerical Study of Moisture Distribution and Shrinkage Crack Propagation in Cross Section of Timber Members

Prediction Model of Shrinkage Crack Propagation in Cross-Section of Timber Components

Crack Propagation And Fracture Process Zone (Fpz) Of Wood In The Longitudinal Direction Determined Using Digital Image Correlation (Dic) Technique

Numerical Modelling of Drying Induced Cracks in Wood Discs Using the Extended Finite Element Method

Prediction of moisture-induced cracks in wooden cross sections using finite element simulations

XFEM Study of Crack Propagation in Logs after Growth Stress Relaxation and Drying Stress Accumulation

Modeling crack propagation in wood by extended finite element method

Simulation and analysis of infilled-wall cracks' development by shrinkage using semi-discrete and whole type model

Flexural Performance of Timber Beams with Shrinkage Crack

Bearing capacity of timber beams with shrinkage cracks

Crack influence on load-bearing capacity of glued laminated timber using extended finite element modelling

Experimental Study and Numerical Simulation on Flexural Behaviour of Longitudinally Cracked Wood Beams

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

Experimental and numerical analysis on fire behaviour of loaded cross-laminated timber panels

Prediction Distribution Model of Moisture Content in Laminated Wood Components

Moisture dependent bending mechanical properties of Chinese fir

Experimental Investigation on the Rheological Behavior of Timber in Longitudinal and Transverse Compression

Numerical modelling of desiccation shrinkage and cracking of soils

Investigation on the char crack growth of densified wood

Numerical Analysis on Tensile Performance of Bolted Glulam Joints with Initial Local Cracks

A novel constitutive model for the porosity related super-large deformation and anisotropic behavior of wood under perpendicular to grain compression