Abstract:Due to the inability of grid-following control methods to compensate for the comprehensive reduction in system inertia, strength, and short-circuit capacity caused by the decreased proportion of synchronous machines, the grid exhibits insufficient resilience to disturbances, leading to severe stability risks in terms of rotor angle, frequency, and voltage. Grid-forming inverters have emerged to address this issue. During symmetrical faults, the low-voltage ride-through of grid-forming inverters often involves freezing the reactive power loop, resulting in a direct output of higher voltage and reactive current. However, an increase in reactive power command leads to a sharp rise in the internal potential magnitude of grid-forming inverters. Upon clearance of the grid fault, the excessively high internal potential may cause a rapid, short-term increase in terminal voltage, potentially resulting in overvoltage, which is detrimental to the operation of grid-connected equipment. In response to this issue, this paper proposes an adaptive low-voltage ride-through control strategy for grid-forming inverters under symmetrical faults controlled by a virtual synchronous machine control method. Initially, a virtual synchronous machine control model is established. Limiting current is achieved through the construction of a fixed virtual impedance loop. The issues associated with fixed virtual impedance current limiting are analyzed, leading to the proposal of an adaptive virtual impedance control strategy. Finally, the feasibility of the proposed method is verified through simulation experiments.

High Voltage Ride-through Control Strategy of Grid-connected Inverter for Renewable Energy Systems

High Voltage Ride-Through Control Strategy of Grid-Side Converter for DFIG-based WECS.

Asymmetrical High Voltage Ride Through Control Strategy of Grid-Side Converter for Grid-Connected Renewable Energy Equipment

A Low-Voltage Ride-Through Control Strategy for Three-Phase Grid-Connected Pv Systems

Zero-Voltage Ride-Through of Flexible Power Control Strategy in Single-Phase Grid-Connected Photovoltaic Inverters

Improved reliability of single-phase PV inverters by limiting the maximum feed-in power

A P-Q Coordination Based Model Predictive Control for DFIG High-Voltage Ride Through

Modeling and Control Technology of Grid Side Converter under Transient Harmonic Disturbance

A High-voltage Ride-through Control Strategy for DFIG Based Wind Turbines Considering Dynamic Reactive Power Support

Improved VSG Control Strategy for Wind Turbines Connected to Non-Synchronized Grid under Commutation Failure

Low Voltage Ride-Through of Single-Phase Transformerless Photovoltaic Inverters

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Grid-Forming Control for DFIG Based Wind Farms to Enhance the Stability of LCC-HVDC

Modeling and Overvoltage Suppression Analysis of Grid-connected Converter with VSG Control Strategy under Commutation Failure

Overvoltage ride through control strategy for improving voltage support capability of virtual synchronous generator

Internal Energy Based Grid-Forming Control for MMC-HVDC Systems With Wind Farm Integration

High Voltage Ride Through Strategy For DFIG Considering HVDC System Converter Blocking

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Grid-Impedance-Based Transient Current Control for Offshore Wind Turbines under Low-Voltage Fault

A harmonic current suppression control strategy for droop-controlled inverter connected to the distorted grid

Full Grid Voltage Feedforward for Critical Mode LCL-Type Single-Phase Grid-Tied Inverters With Physical Interpretations