Abstract:There are stochastic power fluctuations of AC tie-lines in interconnected power systems under normal operating conditions. Based on historical data of an interconnected power grid integrating two large regional power grids, the statistical characteristics of power fluctuation and frequency deviation of the tie-line and the area control error (ACE) of the interconnected power grid are analyzed, and analysis results show that: the tie-line power fluctuation presents good normal distribution characteristics; the system frequency deviation evidently differs from the normal distribution for the reason that the frequency control reduces the probability of frequency variation greater than 0.03 Hz; the ACE in both controlled areas basically follows normal distribution. It is considered that the tie-line power fluctuation is caused by the ACEs of the two controlled areas at both terminals of the tie-line, so the RMS value of tie-line power fluctuation can be calculated by the RMS values and correlation coefficients of ACEs of both controlled areas, and then the distribution of tie-line power deviation extent can be estimated. The currently used T standard is analyzed and following conclusions are obtained: to realize the goal of controlling tie-line power variation, it's only required that the sum of responsibility degree index limits of the two controlled areas is less than 2, and it is not necessary to make the threshold of responsibility degree index limit in each controlled area equal to 1; to achieve a fair and rational scheme, it is necessary to carry out a detailed research on the allocation of the threshold of responsibility degree index limit between the two controlled areas when different factors should be taken into accounts synthetically.

T2 Criteria for Evaluating Interchange Power Error on Tie Lines of an Interconnection

Analysis on statistic characteristic and evaluation criteria of tie-line stochastic power fluctuation in interconnected power systems

An ACE-based Method for Evaluating the Impact of DC Interconnecting or AC Tie Line Fault

Control strategy designing of hybrid compensator based on APF and TSC

Critical Line Identification in Power Systems By Combined Use of Objective Weighting and Inter-Degree Measure Methods

Reliability assessment of power systems considering reactive power sources

Comprehensive Evaluation of Power Quality Based on Improved TOPSIS-RSR Method

Research on AGC Assessment Criteria's Adaptability

Study on Current Compensation Method of Differential Protection for Teed Lines

Two-interdependent-performance Multi-State System: Definitions and Reliability Evaluation

Analysis and control of stochastic power fluctuations on the tie-line of interconnected power systems

IMPROVEMENT OF THE APPARENT IMPEDANCE ANGLE SEPARATION CRITERION

Mechanism and peak value calculation of AC tie-line power swing caused by DC blocking

A Distributed Power Transfer Limit Calculation Method for Multi-Area Interconnection Power Networks

Tie-Line Scheduling Based on Equivalents of Regional Power Grids

Power transfer limit calculation for multi-area interconnected power networks

Analysis on Stochastic Power Fluctuations of AC Tie-lines Between Interconnected Power Systems Part Two Cause Analysis and Measures

An online method for the accuracy level evaluation of the phasor measurement units

Theoretical Analysis on Tie-Line Power Oscillation of Two-Area Interconnected System

Critical Node Identification in Power Systems Based on Improved Node Importance Contribution Matrix

T–S Dynamic Fault Tree Analysis Method Considering Imperfect Coverage Based on Phase-Type Distribution