Abstract:This paper provides a detailed analysis of how a rotary regenerative air preheater's performance parameters such as effectiveness, fluid and metal temperature fields, and ammonium bisulfate(ABS) deposition area vary with rotor rotational speed. A tri-sector rotary regenerative air preheater for a 600MW unit was studied as an example by use of effectiveness modified number of transfer units (epsilon-NTU0) method and a finite difference method. The findings of the research are as follows: (1) There is a nonlinear relationship between matrix temperature distribution and rotational angle, and the degree of nonlinearity, represented by unsteady heat transfer correction factor IT, increases with decreasing rotational speed and varies between sectors; (2) There exist two equilibrium positions around the intersection points of matrix temperature curves for different rotational speeds, one occurring in the heating period and the other in the cooling period; (3) The act of reducing;the rotor speed has two effects on ABS deposition. On the one hand, the height range of possible ABS deposition area will expand as the matrix temperature within the first third of gas sector's angle range further decreases with decreasing rotational speed. On the other hand, after the rotational speed falls below a certain level, the hot-end matrix temperature climbs above the ABS formation temperature during part of the heating period, resulting in gasification and decomposition of the condensed product. The combined effect is yet to be examined through further theoretical and empirical analyses. (4) The trends of average outlet temperatures of primary and secondary air depend on rotor rotation direction and angles of sectors. (5) The effectiveness values calculated by epsilon-NTU0 method are greater than those acquired by the finite difference method, especially at low rotor rotational speeds.

Self-correction Algorithms to Estimate the Temperature Distribution of Rotary Air Preheaters

Numerical Analysis of the Coupling Between Heat Transfer and Deformation in Rotary Air Preheater

Estimation of the Direct Leakage of Rotary Air Preheaters Based on Temperature Distribution Modeling

Correction Algorithm for Calculating Heat Transfer in Air-Cooling Condenser Based on Analyzing Steam Condensation Locations

Research on the Heat Balance Calculation of the Tri-Sectional Regenerative Air Preheater

Bisector Air Preheater Performance Evaluation Based on Numerical Finite Difference Method

The Optimal Thermodynamic Calculation of Trisector Air Preheater

Thermal deformation prediction based on the temperature distribution of the rotor in rotary air-preheater

Adaptive Fan-coil Outlet Wind Temperature Control with Correction Module of Thermistor for the ASHPAC System

ICOPE-15-C074 Evaluation of the Heat Transfer Performance of a Tri-Sector Rotary Air Pre-Heater Based on ASME PTC 4.3

Influence Of Rotational Speed On Thermal Performance Of Tri-Sector Rotary Regenerative Air Preheater

Accuracy Self-Adaptive Method of Fin and Tube Heat Exchanger Simulation Software

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

TREATMENTS ON IMPROVING THE ACCURACY OF CONJUGATE HEAT TRANSFER SIMULATION

Experimental Study of Flow and Heat Transfer in Rotary Air Preheaters with Honeycomb Ceramics and Metal Corrugated Plates

Experiments Research on Thermal Performance of Heat Transfer Elements in Rotary Air Preheater

Technical and Economical Analysis of a Novel Rotary Air Preheater System

Investigation on pressure drop and heat transfer performances of plate-fin iron air preheater unit with experimental and Genetic Algorithm methods

The Study on Heat Transfer Model and Algorithm of Multi-Sectional Regenerative Air Heater in Power Plant Boiler Based on Analytical Method

Coupled Heat Transfer Predictions of Thermal Environment for a Turbine Rotor

Experimental studies on measuring the cold end metal temperature of 600 MW rotating air heater