Abstract:High-voltage and high-frequency stresses comprising of AC and DC components are encountered across the surge arresters at various nodes in HVDC stations. There is a need to generate these stresses to evaluate surge arresters employed at different locations in the HVDC networks. In the present work, an attempt is made to develop complex waveforms using a novel single-stage DC–AC converter. The presented switched-mode converter is based on a coupled inductor which gives an extra degree of freedom to obtain a higher gain with the modulation in the duty ratio. Fixing the turns ratio of the coupled inductor, the duty ratio is appropriately modulated to generate the complex waveform of high frequency and high amplitude. The proposed converter offers a single-stage solution for DC–AC inversion using pulse width modulation, with fewer components, higher power density, and the ability to generate a frequency of 600 Hz. The detailed converter and controller design analysis is discussed in the present investigation. The breakdown operation of the surge arrester demands a massive short-circuit current from the source side, which may be difficult to obtain if a high-gain amplifier is used without proper protection. The presented switched-mode converter-based approach rectifies the issue of the short-circuit current during the insulator breakdown. A simulation study is performed to validate the circuit for both positive and negative buck-boost regions. Further, a hardware setup is developed to verify the generation of high-frequency and high-voltage complex waveforms. The developed converter could be widely used for insulation evaluation and condition monitoring of various high-voltage equipment.

Design of a DC Surge Generator Based on Variable Speed Integration

Study of a Single-stage Three-phase PFC DC/DC Converter With Series-parallel Connected Transforms

Surge Process of a High-Speed Axial–Centrifugal Compressor

Design of Interleaved Boost Converter in Energy-Feedback Electronic Power Load

Voltage Slew Rate Design with Soft Switching Technique

Design of CRM AC/DC Converter for Very High-Frequency High-Density WBG-based 6.6kw Bidirectional On-Board Battery Charger

Design of High-gain Converter for Low Input Voltage and High Input Current in Energy Feedback Electronic Load System

Design of optimal anti-surge control for blast furnace blowers

Study of Interleave DC/DC Converter in Energy Feedback Electronic Power Load

An Improved Method to Design Surge Generators

Method to Design Surge Generators

Development of a Novel 0~10kV Continuous Adjustable Portable Combination Wave Generator

MHz Level Two-Stage ZVS DC-DC Converter with Wide Input and Output Voltage Ranges

Active Surge Control for Variable Speed Axial Compressors.

Novel complex waveform generator for evaluation of HVDC station class surge arresters

Four Key Problems in the Design of a DC High Voltage Generator

Design and implementation of DC-to-DC converter topology for current regulated lightning generator

Design of a Portable Intelligent DC High Voltage Generator

Design of a High-Voltage Arbitrary Waveform Generator Using a Modular Cascaded H-Bridge Topology

Design Method for Variable Frequency Brushless Synchronous Generators

Design of Power Generator of Electrosurgical Generator