Four Key Problems in the Design of a DC High Voltage Generator

JIANG Xiu-chen,Lubo Zhou,Yitao Zeng,QingLong Xu
DOI: https://doi.org/10.3969/j.issn.1003-6520.2007.06.021
2007-01-01
Abstract:Four key problems of DC high voltage generator which uses the technology of switching power supply are introduced.The four key problems are listed below: design of the whole project,drive circuit for MOSFET,RCD snubber and the design of high frequency boost transformer.The whole system includes two sections: power section and controlling section.The power section is based on the technology of high frequency inverter and voltage multiplier circuit.The controlling section works with the combination of MCU and CPLD.A316J is used to design drive circuit for MOSFET.A316J,a kind of drive chips from Agilent company,can connect with MCU or CPLD conveniently.The drive circuit based on A316J has strong drive ability which can turn on or shut down MOSFET within 200 nanoseconds.It can also shut down MOSFET with negative voltage which can avoid short circuit.RCD snubber is applied to protect MOSFET and lower electro magnetic interference(EMI).The parameters of RCD snubber are calculated in detail and adjusted through experiments.Multitrough framework is used to make high frequency boost transformer in order to increase efficiency.Multitrough framework can decrease parasitic capacitance which is the main factor causing wastage of energy.The windings of the transformer are imbued with epoxy glues to enhance the capability of insulation.In the debugging process,full load test and 1.1 times output voltage test have been implemented.The debugging results shows that the 120kV/5mA high voltage generator based on the technology introduced above can work reliably now.
What problem does this paper attempt to address?