Abstract:The electromechanical co-simulation method was used to simulate and analyze the 6-DOF (degrees of freedom) positioning and micro-vibration isolation functions of the platform in order to analyze the working performances of a contactless positioning and vibration isolation platform which works at space microgravity environment. The working principle of the contactless positioning and vibration isolation platform was introduced. The exciting unit, position measuring unit and acceleration measuring unit of the platform were made up by contactless biaxial actuators, biaxial position sensitive detectors and uniaxial accelerometers according to space symmetry layout scheme. The controller of the platform was designed based on position and acceleration feedback. Then the mechanical system simulation model and the closed-loop control system simulation model based on position and acceleration feedback was established by ADAMS and MATLAB/Simulink, respectively, which together set up the electromechanical co-simulation model of the platform. The positioning and vibration isolation performances of the platform were simulated by the co-simulation model. Results show that the 6-DOF displacement and angular displacement control errors of the platform are less than 10 μm and 2×10−5 rad respectively under small range positioning mode. The suppression efficiencies of the platform for 6-DOF direct sinusoidal disturbances with frequency range of 0.01−1 Hz and 1−100 Hz are 39−73 dB and 19−73 dB, respectively. The relative displacements between the floater and the stator are less than 1 mm during vibration isolation control process under vibration isolation mode.

Analysis on the factors affecting the measuring accuracy of rotational inertia of air-floated platform

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Study and Design on a Minimal Damp Air-floating Platform for Picosat's Simulation Testing

Novel Measurement Method for Determining Mass Characteristics of Pico-Satellites

Research on Testing Method of the Rotary Inertia of the Three-axis Air Bearing Testbed

Performance Analysis of Three-Axis Inertial Platform Based on ANSYS

Astronaut Mass Measurement Using Linear Acceleration Method and the Effect of Body Non-Rigidity

Accuracy Limitating Factor Analysis and Strategy of the Inertial Platform Gyro Misalignment Angle Identification

Analysis of High Precision Moment of Inertia Measurement Method Based on Torsion Pendulum Method

Removing adverse effect of measurement process in flotation method

Design and Simulation of an Air Floating Platform with Zero Gravity Self-adjusting

Measurement and Characterization of Rotational Errors of Aerostatic Bearings in Subnanometer Accuracy

The Ground Test System of Double Layer Air Floating Platform and Its Application

Measure principle and signal acquisition of airborne gravity gradiometer based inertial platform

Structure Static Force and Static Characteristic Calculate Analysis for Double Gas-suspension Test Bench

Research on the rotational accuracy measurement of an aerostatic spindle in a rolling bearing performance analysis instrument

Ultra Precise Measurement For Rigidity Of Self-Acting Air Bearing Based On Triangular Method

Application of Sensitivity Analysis in Inertial Platform Error Parameters Identification

Analysis of Air Bearing Torsion Pendulum Moment of Inertia Measurements Including Nonlinear Oscillation and Damping

Angular Momentum Vector Drift Model and Its Parameter Identification for High-Speed Rotational Sphere

Deviation Analysis of Rotational Inertia Measurement Based on Torsion Bar Method