Abstract:With the success of Shenzhou spacecraft rendezvous and docking with Tiangong-1 and Tiangong-2, the future tasks of the space station such as space garbage clean-up requires the control of spacecraft attitude to be more and more accurate. Because of the high cost of the attitude control and regulation test in space, the experiments are usually carried out on the ground. In order to simulate the microgravity environment of space, the gravity of the aircraft model is needed to be overcame in the ground test. Presently, there are two ways that not only overcome the gravity of the aircraft model but also make the aircraft to freedom of movement: one is to use non-contact force to overcome the gravity, such as electromagnetic force, but this approach requires the control of non-contact force to be very accurate, which needs difficult technology and faces the high cost; another way is to use liquid buoyancy to overcome gravity, which only needs to ensure that the average density of the aircraft model is equal to the density of the liquid, and the aircraft model can be suspended at any position in the liquid, using the thrust produced by the propeller to carry out the free movement. This technique is not difficult and low cost, but in the control of aircraft model movement needs to overcome the force and torque generated by the liquid. Therefore, the buoyancy of water is used to overcome the gravity of the vehicle model, and a neutral buoyancy force is obtained. Then the numerical analysis technique is used to calculate the hydrodynamic coefficient of the model. At the same time, by changing the propeller thrust, the response curves of aircraft moving in vertical and horizontal directions are simulated and verified. The results show that the model can reach a new equilibrium state in 0.8~1 seconds. This paper provides a theoretical basis for guiding the tunnel test of aircraft model, which is one of the important links in the iterative design of space vehicles.

Study and Design on a Minimal Damp Air-floating Platform for Picosat's Simulation Testing

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

An Optimization Method of Separation Parameters for Pico-Satellite by Minimizing External Moment

Nonlinear Programming Control Using Differential Aerodynamic Drag for CubeSat Formation Flying

Novel Measurement Method for Determining Mass Characteristics of Pico-Satellites

Hardware-in-the-Loop Simulation Method for Pico-satellite Attitude Determination and Control System

Design and On-Orbit Performance of the Attitude Determination and Control System for the ZDPS-1A Pico-Satellite

Design and Simulation of an Air Floating Platform with Zero Gravity Self-adjusting

Physical Simulation Experiment for Flexible Satellite Control with Vibration Information Feedback

Design of Clearance Fit Between Pico-Satellite and Its Separation Mechanism Based on Thermal-Structure Coupling

Research on Testing Method of the Rotary Inertia of the Three-axis Air Bearing Testbed

Numerical Simulation of Neutral Buoyancy Experiment for Spacecraft

Three-axis air-bearing based platform for small satellite attitude determination and control simulation

Design of Reaction Wheels Based on COTS Device for Nano?Satellite

Full physics simulation of satellite attitude control system based on three-axis air-floating platform

Compact and lightweight 3D printed platform for testing attitude determination and control system of small satellites

Matlab Gui-Based Simulation Platform Design of Flexible Satellite Attitude Control and Vibration Suppression

A Testbed for a three dimensional Pico-Sphere Satellite-Simulator(T3Dpilare)

Air bearing platforms for simulation of spacecraft attitude control systems

A 2-DOF drag-free control ground simulation system based on Stewart platform

Research on three axis air bearing platform simulation system for small satellite attitude control