Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Readout Electronics for CEPC Semidigital Hadron Calorimeter Preprototype

Readout Electronics Research for CEPC Semi-Digital Hadron Calorimeter Pre-prototype

The Readout Electronics Research Design and Development for CEPC Scintillators Electromagnetic Calorimeter Prototype

Preliminary Conceptual Design about the CEPC Calorimeters

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design of Sc-ECAL Prototype for CEPC and Performance of First Two Layers

A Study of Sensitive Elements of CEPC-AHCAL

Scintillator Tile Batch Test of CEPC AHCAL

Design and Optimization of the CEPC Scintillator Hadronic Calorimeter

Study of SiPM for CEPC-AHCAL

Data Acquisition System for CEPC Vertex Detector Prototype

Digital Hadron Calorimetry for the Linear Collider using GEM based Technology

PFA Oriented ECAL Optimization for the CEPC

Readout Electronics for the Zero Degree Calorimeter at HIRFL-CEE Experiment

Development of a double-GEM detector using the self-stretching technique for digital hadron calorimetry

A Low Noise Apd Readout Asic For Electromagnetic Calorimeter In Hiepa

Beam Test of a Monolithic Active Pixel Sensor for the CEPC Vertex Detector

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

The Status of CEPC

Beam test of a baseline vertex detector prototype for CEPC

The 1m3 Semidigital Hadronic Prototype