Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Development of a double-GEM detector using the self-stretching technique for digital hadron calorimetry

Digital Hadron Calorimetry for the Linear Collider using GEM based Technology

A new technique for assembling large-size GEM detectors

Feasibility Study of TPC Detector at High Luminosity Z Pole on the Circular Collider

Beam Studies of the Segmented Resistive WELL: a Potential Thin Sampling Element for Digital Hadron Calorimetry

Performance of a Large-Area GEM Detector Prototype for the Upgrade of the CMS Muon Endcap System

R&D on GEM Detectors for Forward Tracking at a Future Electron-Ion Collider

A Study of Sensitive Elements of CEPC-AHCAL

Construction of a Triple-GEM Detector Using Commercially Manufactured Large GEM Foils

Construction of the Digital Hadron Calorimeter

Investigation on the performance of a thick ceramic gas electron multiplier

GEMs with Double Layred Micropattern Electrodes and their Applications

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Performance Study of a GEM-TPC Prototype Using Cosmic Rays

A Time Projection Chamber with GEM-based Readout

Performance of a Small AT-TPC Prototype

GEM-based TPC with CCD Imaging for Directional Dark Matter Detection

Investigation and improvements of the mechanical structure of cylindrical GEMs for the BESIII experiment

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

Design and optimization of a hadronic calorimeter based on micropattern gaseous detectors for a future experiment at the Muon Collider

Performance of a triple-GEM detector with capacitive-sharing 3-coordinate (X-Y-U)-strip anode readout