Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

PFA Oriented ECAL Optimization for the CEPC

Design and Optimization of the CEPC Scintillator Hadronic Calorimeter

Preliminary optimization study on the PFA-based GSHCAL for the CEPC

Design of Sc-ECAL Prototype for CEPC and Performance of First Two Layers

A Study of Sensitive Elements of CEPC-AHCAL

Study of SiPM for CEPC-AHCAL

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Scintillator Tile Batch Test of CEPC AHCAL

Development of Future Electromagnetic Calorimeter Technologies and Applications for the Electron-Ion Collider with GEANT4 Simulations

Design and test for the CEPC muon subdetector based on extruded scintillator and SiPM

Optimization of layer composition for ILD ECAL

Cross Section and Higgs Mass Measurement with Higgsstrahlung at the CEPC

Optimization Study of the Drift Field for TPC Detector in CEPC

Simulation and reconstruction of particle trajectories in the CEPC drift chamber

CEPC-on-Gaussino: an application of Gaussino simulation framework for CEPC experiment

The Physics potential of the CEPC. Prepared for the US Snowmass Community Planning Exercise (Snowmass 2021)

H→e+e−at the CEPC: Initial State Radiation Effect with MadGraph

Calorimetry at FCC-ee

Simulation and Prototype Testing of Multi-Wire Drift Chamber Arrays for the CEE

Feasibility Study of TPC Tracker Detector for the Circular Collider

Measurement of H → Μ + Μ − Production in Association with a Z Boson at the CEPC