Abstract:Laser Thomson scattering (LTS) is a minimally invasive measurement technique used for determining electron properties in plasma systems. Sheath model closure validation requires minimally invasive measurements of the electron properties that traverse the boundaries between the bulk plasma, the presheath, and the plasma sheath. Several studies have probed the radial properties along the surface of discharge electrodes with laser-based diagnostics and electrostatic probes. These measurements provide valuable insight into the electron properties in this dynamic region. However, sheath model calibration requires plasma property measurements perpendicular to plasma bounding surfaces, in this case, along the electrode normal vector between discharge electrodes. This work presents the development of a discharge plasma cell and laser Thomson scattering system with a measurement volume step of 1 mm normal to plasma bounding surfaces. The laser Thomson scattering measurements are made between a set of discharge electrodes separated by ∼25 mm that are used to generate a pulsed argon plasma. The spatial distribution of electron temperature and density is measured at several discharge voltages between 8 and 20 kV at a pressure of 8 Torr-Ar. It is determined that the system is statistically stationary and resembles a classic DC discharge plasma. The results are some of the first laser diagnostic-based “between electrode” measurements made along the plasma bounding electrode normal vector. A one-dimensional sheath model is applied to determine the near cathode electron properties, and it is determined that the edge of the presheath is probed in the high-voltage cases. As the lengths of the presheath and sheath decrease with decreasing voltage, the region recedes below the closest probed point to the cathode. To improve the performance of the diagnostic, the step size of the interrogation volume should decrease by an order of magnitude from 1 mm to less than 100 μm, and the data acquisition strategy should be revised to increase the signal-to-noise ratio.

Improvement in Thomson Scattering Diagnostic Precision Via Fitting the Multiple-Wavenumber Spectra Simultaneously

Microwave Diagnostics System in the HL-2A Tokamak

An Algorithm to Enhance the Capability of Imaging Thomson Scattering

Precisely Fitting Thomson Scattering Spectrum in Laser-Produced Plasmas

A thorough experimental assessment of THz-TDS plasma diagnostic techniques for nuclear fusion applications

Demonstration of improvement in the signal-to-noise ratio of Thomson scattering signal obtained by using a multi-pass optical cavity on the Tokyo Spherical Tokamak-2

Electron Density Measurement Via Dual-Angle Thomson Scattering Diagnosis

High resolution Thomson scattering system for steady-state linear plasma sources

An incoherent Thomson scattering system for measurements near plasma boundaries

Recovering non-Maxwellian particle velocity distribution functions from collective Thomson-scattered spectra

Optical Design of the Lyman Alpha Based Beam Emission Spectroscopy（lab）diagnostic on the HL-2A Tokamak

Design and development of a single-laser 2D Thomson scattering measurement system for TS-6 merging tokamak/magnetic reconnection experiments

Precision Spectroscopy and Electron-Ion Scattering

Development of Thomson Scattering System on Shenguang-III Prototype Laser Facility.

Design of a Thomson scattering diagnostic for the SMART tokamak

Progress and challenges in the design of ITER's polarimetric Thomson scattering diagnostic system

Detective Studies of Soft X-ray Tomography on Controlled Thermonuclear Fusion Device

Double-filter High-Resolution Soft X-Ray Tomographic Diagnostic for Investigating Electron Acceleration in TS-6 Reconnection Merging Experiments

Two-dimensional Thomson scattering in high-repetition-rate laser-plasma experiments

Collective Thomson Scattering from High-Temperature High-Density Plasmas Revisited

Development of A Real-Time Ion Spectrometer with A Scintillator for Laser-Driven Ion Acceleration Experiments