Abstract:In recent years, the overall performances of inertial Micro-Electro Mechanical Sensors (MEMSs) exhibited substantial improvements to values very close or similar to so-called tactical-grade sensors. However, due to their high costs, numerous researchers are currently focusing on the performance enhancement of cheap consumer-grade MEMS inertial sensors for all those applications (as an example, small unmanned aerial vehicles, UAVs), where cost effectiveness is a relevant request; the use of redundancy proves to be a feasible method for this purpose. In this regard, the authors propose, hereinafter, a suitable strategy aimed at fusing raw measurements provided by multiple inertial sensors mounted on a 3D-printed structure. In particular, accelerations and angular rates measured by the sensors are averaged according to weights associated with the results of an Allan variance approach; the lower the noise figure of the sensors, the greater their weight on the final averaged values. On the other hand, possible effects on the measurements due to the use of a 3D structure in reinforced ONYX (a material capable of providing better mechanical specifications for avionic applications with respect to other solutions for additive manufacturing) were evaluated. The performance of a prototype implementing the considered strategy is compared with that of a tactical-grade inertial measurement unit in stationary conditions, exhibiting differences as low as 0.3 degrees in heading measurements. Moreover, the reinforced ONYX structure does not significantly affect the measured values in terms of both thermal and magnetic field while assuring better mechanical characteristics with respect to other 3D printing materials, thanks to a tensile strength of about 250 MPa and a specific stacking sequence of continuous fibers. Finally, a test conducted on an actual UAV highlights performance very close to that of a reference unit, with root-mean-square error in heading measurements as low as 0.3 degrees in observation intervals up to 140 s.

Performance Enhancement Method for Angular Rate Measurement Based on Redundant MEMS IMUs.

A Fusion Algorithm for Pico-Satellite Attitude Determination Using Low Cost Mems-Based Sensors

Gyroscope-Reduced Inertial Navigation System for Flight Vehicle Motion Estimation

Attitude Measurement Based on Differential Array of MEMS Inertial Sensors

High Precision Tri-Axial Mems Gyroscope Module Based on Redundant Implementation and Sensor Fusion

Innovative Fusion Strategy for MEMS Redundant-IMU Exploiting Custom 3D Components

New calibration method using low cost MEM IMUs to verify the performance of UAV-borne MMS payloads

A New Calibration Method Using Low Cost MEM IMUs to Verify the Performance of UAV-Borne MMS Payloads

Method for measuring non-stationary motion attitude based on MEMS-IMU array data fusion and adaptive filtering

High Precision Attitude Estimation Based on Differential IMU Array

Performance Enhancement of Consumer-Grade MEMS Sensors through Geometrical Redundancy

Dynamic Attitude Estimation Improvement for Low-cost MEMS IMU by Integrating Low-cost GPS

A Miniature Integrated Navigation System for Rotary-Wing Unmanned Aerial Vehicles

The Design Of Attitude Measurement Unit Based On Multiple Mems Gyros

Improving the Measurement Accuracy of the MEMS IMU Array by a New Calibration and Fusion Technology

An improved method to integrate low-cost sensors for the navigation of small UAVs

A Combined System of Redundant MEMS and Laser Radar

Attitude Measurement for High-Spinning Projectile with a Hollow MEMS IMU Consisting of Multiple Accelerometers and Gyros

Globally Asymptotic Stable Attitude Estimation with Application to MEMS Sensors

A Low-Cost Attitude Determination Algorithm Based on MEMS IMU/dual-antenna GNSS Receiver for UAVs

Roll Angular Rate Measurement for High Spinning Projectiles Based on Redundant Gyroscope System