Abstract:The Laser-IMU boresight calibration is the precondition for an Unmanned Aerial Vehicle (UAV)-Light Detection and Ranging (LiDAR) system (ULS). The existing methods achieve good performance for calibrating ULSs with high-precision positioning and orientation systems (POS) (e.g., APX-15), in which, the systematic errors of the high-precision POS can be ignored, only the boresight parameters are estimated. However, these methods have difficulties in calibrating the low-cost ULSs with low-precision POS. To overcome the impact of the systematic errors of the low-precision POS on boresight calibration, an aerial-triangulation aided boresight calibration is proposed in this paper. It simultaneously estimates the laser-IMU boresight angles and system states (e.g. trajectory) by setting the point clouds derived from aerial-triangulation (AT point clouds) as the reference. Firstly, the planar voxels from the AT point clouds are extracted, due to the fact that they are more reliable in AT point clouds. Secondly, raw laser observations are matched with the extracted planar voxels to establish laser matching observations. Thirdly, a Dynamic Network (DN) is built using the GNSS observations, inertial observations, and laser matching observations to simultaneously optimize the initial laser-IMU boresight angles and the system states. All the sensor observations involved in the ULS are modeled with proper error models, which are essential for analyzing and refining the data quality of the low-cost ULS. The proposed method was tested to calibrate a low-cost ULS, KylinCloud-II, in a calibration field. It showed that the average distance between the laser point clouds and the referenced AT point clouds was decreased from 2.560m (RMSE = 3.88m) to 0.08m (RMSE = 0.99m).

A New Calibration Method Using Low Cost MEM IMUs to Verify the Performance of UAV-Borne MMS Payloads

New calibration method using low cost MEM IMUs to verify the performance of UAV-borne MMS payloads

Accuracy Analysis of MAMS Data Using Direct Georeferencing

The development of an UAV borne direct georeferenced photogrammetric platform for Ground Control Point free applications

A Miniature Integrated Navigation System for Rotary-Wing Unmanned Aerial Vehicles

Real-time single-frequency GPS/MEMS-IMU attitude determination of lightweight UAVs

System Calibration Including Time Delay Estimation for GNSS/INS-Assisted Pushbroom Scanners Onboard UAV Platforms

A Buddy Temporal-Spatial Calibration Method for Airborne Sensors in Multi-UAV Systems

Simultaneous Localization and Mapping of High-Altitude UAVs

Urban Geospatial Information Acquisition Mobile Mapping System Based on Close-Range Photogrammetry and IGS Site Calibration

Performance Enhancement Method for Angular Rate Measurement Based on Redundant MEMS IMUs.

Anin Situhand Calibration Method Using a Pseudo-Observation Scheme for Low-End Inertial Measurement Units

AERIAL-TRIANGULATION AIDED BORESIGHT CALIBRATION FOR A LOW-COST UAV-LIDAR SYSTEM

A 2D Georeferenced Map Aided Visual-Inertial System for Precise UAV Localization

Accuracy Assessment of a UAV Direct Georeferencing Method and Impact of the Configuration of Ground Control Points

Vector-Aided In-Field Calibration Method for Low-End MEMS Gyros in Attitude and Heading Reference Systems

Calibration of Small and Low-Cost UAV Video System for Real-Time Planimetric Mapping

A Novel MEMS-RIMU Self-Calibration Method Based on Gravity Vector Observation

An improved method to integrate low-cost sensors for the navigation of small UAVs

A Geometric Auto-Calibration Method for Multiview UAV-Borne FMCW SAR Images

A Novel Positioning Module and Fusion Algorithm for Unmanned Aerial Vehicle Monitoring