Abstract:Unmanned aerial vehicle (UAV) navigation has recently been the focus of many studies. The most challenging aspect of UAV navigation is maintaining accurate and reliable pose estimation. In outdoor environments, global navigation satellite systems (GNSS) are typically used for UAV localization. However, relying solely on GNSS might pose safety risks in the event of receiver malfunction or antenna installation error. In this research, an unmanned aerial system (UAS) employing the Applanix APX15 GNSS/IMU board, a Velodyne Puck LiDAR sensor, and a Sony a7R II high-resolution camera was used to collect data for the purpose of developing a multi-sensor integration system. Unfortunately, due to a malfunctioning GNSS antenna, there were numerous prolonged GNSS signal outages. As a result, the GNSS/INS processing failed after obtaining an error that exceeded 25 km. To resolve this issue and to recover the precise trajectory of the UAV, a GNSS/INS/LiDAR integrated navigation system was developed. The LiDAR data were first processed using the optimized LOAM SLAM algorithm, which yielded the position and orientation estimates. Pix4D Mapper software was then used to process the camera images in the presence of ground control points (GCPs), which resulted in the precise camera positions and orientations that served as ground truth. All sensor data were timestamped by GPS, and all datasets were sampled at 10 Hz to match those of the LiDAR scans. Two case studies were considered, namely complete GNSS outage and assistance from GNSS PPP solution. In comparison to the complete GNSS outage, the results for the second case study were significantly improved. The improvement is described in terms of RMSE reductions of approximately 51% and 78% for the horizontal and vertical directions, respectively. Additionally, the RMSE of the roll and yaw angles was reduced by 13% and 30%, respectively. However, the RMSE of the pitch angle was increased by about 13%.

[Rupture of extrauterine pregnancy during simultaneous intrauterine pregnancy].

A Miniature Integrated Navigation System for Rotary-Wing Unmanned Aerial Vehicles

Autonomous Navigation and Attitude Determination System Design for Micro-Nano Satellites with Limited Sensors

New calibration method using low cost MEM IMUs to verify the performance of UAV-borne MMS payloads

A New Calibration Method Using Low Cost MEM IMUs to Verify the Performance of UAV-Borne MMS Payloads

Dynamic Attitude Estimation Improvement for Low-cost MEMS IMU by Integrating Low-cost GPS

A 2D Georeferenced Map Aided Visual-Inertial System for Precise UAV Localization

Research on Navigation Technology of Small UAV Based on MEMS Sensor

INS/GNSS Integration for Aerobatic Flight Applications and Aircraft Motion Surveying

Robust UAV Position and Attitude Estimation using Multiple GNSS Receivers for Laser-based 3D Mapping

A GNSS/INS/LiDAR Integration Scheme for UAV-Based Navigation in GNSS-Challenging Environments

Can Superextended Lymph Node Dissection be Justified for Gastric Cancer with Pathologically Positive Para-aortic Lymph Nodes?

Robust attitude estimation for an unmanned aerial vehicle using multiple GPS receivers

Design and Implementation of Low Cost Integrated Navigation System for Mini Autonomous Helicopter

Differential GNSS and Vision-Based Tracking to Improve Navigation Performance in Cooperative Multi-UAV Systems

A Low Power and Ultra Long Range UAV Attitude Measurement System

A Spatial Localization and Attitude Estimation System for Unmanned Aerial Vehicles Using a Single Dynamic Vision Sensor

Real-Time Onboard 3D State Estimation of an Unmanned Aerial Vehicle in Multi-Environments Using Multi-Sensor Data Fusion

Why do couples discontinue in vitro fertilization treatment? A cohort study.

Development of a Low-Cost AOA/AOS Sensor and Data Processing System for Small-Sized UAVs

A Ground Target Positioning Method Facing Small UAVs