Abstract:To study the time evolution of a molecular state in an ultra-fast chemical reaction, the use of shorter pulses with higher photon energy and narrower bandwidth for both pump and probe is necessary. However, quick and precise measurement of their detailed time structures is a challenge. Over the last decade, great efforts have been made to measure an attosecond extreme ultraviolet (XUV) pulse. To date, several methods have been developed to measure the pulse duration and completely reconstruct it. The attosecond spectral phase interferometry for direct electric field reconstruction (SPIDER) and attosecond frequency-resolved optical gating (FROG) techniques are often used. However, these methods use state-of-the-art experimental set-ups and complicated data analysis procedures. To develop attosecond metrology for practical use (e.g. timing, measurement, evaluation, calibration, optimization, pumping, probing), we propose a quick and analytical method to precisely observe an attosecond XUV pulse with laser-assisted photo-ionization. The method is based on determining the laser-related phase of each streaked electron and using a transfer equation for one-step pulse reconstruction without any time-resolved measurements, iterative calculations, or data fitting procedures. Temporal errors of the pulse reconstruction are calculated from the XUV bandwidth. Because the transfer equation establishes a direct connection between the XUV pulse properties, the crucial laser parameters (peak intensity, phase, carrier envelope phase), the atomic ionization potential, and the measured photoelectron energy spectrum, we can use it to study any one of these properties from other known information and probe the dynamic processes of an ultra-fast reaction.

A Time- and Angle-Resolved Photoemission Spectroscopy with Probe Photon Energy Up to 6.7 Ev.

Time-resolved ARPES with probe energy of 6.0/7.2 eV and switchable resolution configuration

Use of Photoelectron Energy Spectrum Transfer Equation for the Measurement of a Narrowband XUV Pulse

Time- and angle-resolved photoemission spectroscopy with wavelength-tunable pump and extreme ultraviolet probe enabled by twin synchronized amplifiers

A Newly Designed Femtosecond KBe2BO3F2 Device with Pulse Duration Down to 55 Fs for Time- and Angle-Resolved Photoemission Spectroscopy

A newly-designed femtosecond KBe$_2$BO$_3$F$_2$ device with pulse duration down to 55 fs for time- and angle-resolved photoemission spectroscopy

Time-, spin-, and angle-resolved photoemission spectroscopy with a 1-MHz 10.7-eV pulse laser

An Ultrafast Angle-Resolved Photoemission Apparatus for Measuring Complex Materials.

High repetition pump-and-probe photoemission spectroscopy based on a compact fiber laser system

Time-resolved ARPES with Sub-15 Fs Temporal and Near Fourier-limited Spectral Resolution.

An experimental setup for high resolution 10.5 eV laser-based angle-resolved photoelectron spectroscopy using a time-of-flight electron analyzer

Angle-resolved photoemission spectroscopy with 9-eV photon-energy pulses generated in a gas-filled hollow-core photonic crystal fiber

Development of a vacuum ultraviolet laser-based angle-resolved photoemission system with a superhigh energy resolution better than 1 meV.

Ultrafast time- and angle-resolved photoemission spectroscopy with widely tunable probe photon energy of 5.3-7.0 eV for investigating dynamics of three-dimensional materials

Full Diagnostics and Optimization of Time Resolution for Time- and Angle-Resolved Photoemission Spectroscopy

Time- and angle-resolved photoemission spectroscopy of solids in the extreme ultraviolet at 500 kHz repetition rate

Time-resolved ARPES with Tunable 12-21.6 Ev XUV at 400 Khz Repetition Rate.

Laser-based apparatus for extended ultraviolet femtosecond time-resolved photoemission spectroscopy

High-resolution Time- and Angle-Resolved Photoemission Studies on Quantum Materials