Abstract:To study the time evolution of a molecular state in an ultra-fast chemical reaction, the use of shorter pulses with higher photon energy and narrower bandwidth for both pump and probe is necessary. However, quick and precise measurement of their detailed time structures is a challenge. Over the last decade, great efforts have been made to measure an attosecond extreme ultraviolet (XUV) pulse. To date, several methods have been developed to measure the pulse duration and completely reconstruct it. The attosecond spectral phase interferometry for direct electric field reconstruction (SPIDER) and attosecond frequency-resolved optical gating (FROG) techniques are often used. However, these methods use state-of-the-art experimental set-ups and complicated data analysis procedures. To develop attosecond metrology for practical use (e.g. timing, measurement, evaluation, calibration, optimization, pumping, probing), we propose a quick and analytical method to precisely observe an attosecond XUV pulse with laser-assisted photo-ionization. The method is based on determining the laser-related phase of each streaked electron and using a transfer equation for one-step pulse reconstruction without any time-resolved measurements, iterative calculations, or data fitting procedures. Temporal errors of the pulse reconstruction are calculated from the XUV bandwidth. Because the transfer equation establishes a direct connection between the XUV pulse properties, the crucial laser parameters (peak intensity, phase, carrier envelope phase), the atomic ionization potential, and the measured photoelectron energy spectrum, we can use it to study any one of these properties from other known information and probe the dynamic processes of an ultra-fast reaction.

Full Diagnostics and Optimization of Time Resolution for Time- and Angle-Resolved Photoemission Spectroscopy

Ultrafast time- and angle-resolved photoemission spectroscopy with widely tunable probe photon energy of 5.3-7.0 eV for investigating dynamics of three-dimensional materials

High Harmonic Generation Light Source with Polarization Selectivity and Sub-100-μm Beam Size for Time- and Angle-Resolved Photoemission Spectroscopy

High-resolution MHz time- and angle-resolved photoemission spectroscopy based on a tunable vacuum ultraviolet source

Time-resolved ARPES with Tunable 12-21.6 Ev XUV at 400 Khz Repetition Rate.

Time-, spin-, and angle-resolved photoemission spectroscopy with a 1-MHz 10.7-eV pulse laser

Use of Photoelectron Energy Spectrum Transfer Equation for the Measurement of a Narrowband XUV Pulse

A newly-designed femtosecond KBe$_2$BO$_3$F$_2$ device with pulse duration down to 55 fs for time- and angle-resolved photoemission spectroscopy

Time-resolved ARPES with Sub-15 Fs Temporal and Near Fourier-limited Spectral Resolution.

A Newly Designed Femtosecond KBe2BO3F2 Device with Pulse Duration Down to 55 Fs for Time- and Angle-Resolved Photoemission Spectroscopy

Advancing time- and angle-resolved photoemission spectroscopy: The role of ultrafast laser development

Time- and angle-resolved photoemission spectroscopy of solids in the extreme ultraviolet at 500 kHz repetition rate

Time- and Angle-Resolved Photoemission Studies of Quantum Materials

Toward Direct Exploration of the Few-Femtosecond Dynamics of Electronic Coherence and Correlation in Quantum Materials Using Time- and Angle-Resolved Photoemission Spectroscopy

Time-resolved ARPES with probe energy of 6.0/7.2 eV and switchable resolution configuration

High repetition pump-and-probe photoemission spectroscopy based on a compact fiber laser system

Access to the full three-dimensional Brillouin zone with time resolution, using a new tool for pump-probe angle-resolved photoemission spectroscopy

A Time- and Angle-Resolved Photoemission Spectroscopy with Probe Photon Energy Up to 6.7 Ev.

An Ultrafast Angle-Resolved Photoemission Apparatus for Measuring Complex Materials.

Tuning time and energy resolution in time-resolved photoemission spectroscopy with nonlinear crystals