Abstract:Threaded fasteners were developed long time (let’s remember that Archimedes – 287-212 BC – invented the water screw). Nowadays, bolted joints are used in almost all sectors of the industry. But in spite of having been an important machine part for centuries, problems may be encountered with them. They are so common that they are taken for granted and too often, not analyzed as deeply as it should be. The wrong tightening is one of the most frequent causes of ductile rupture and by far the most frequent cause of fatigue failure. The tightening operation is never easy. It is necessary to pay particular attention to the choice of the tightening tool, the process and the control method. The tightening operation may itself cause damage on parts. The tightening load must not be too low, or excessive or not equally distributed among the bolts. These three defects can even be made on the same bolted joint! This impacts badly the performance of the assembly and leads to a shorter lifespan. If insufficient precautions are taken, the real tightening preload on all the bolts will not fit well with the requirements and would be badly distributed. Consequently, the practical conditions are quite different from the hypothesizes which are taken for the initial calculations (analytics or FEM) at the design stage. Thus, the results of the calculations of bolted joints cannot be considered as accurate and reliable. Practically, there are several means to tighten a bolt. The two ways most frequently used are torque wrench and hydraulic bolt tensioner. Torque wrench involves exerting a torque to the bolt head or the nut. Hydraulic bolt tensioner applies a traction load directly on the bolt. It is well known that bolt tensioners give better accuracy and homogeneity in the final tightening load than the torque method, but the tension load applied with the tensioner must be higher than the final remaining tightening load. So, the paper focusses on the hydraulic tensioner to show how the tightening load can be obtained from the applied tension load and to propose a way to optimize and secure the tightening process. However, for the reasons above mentioned it appears necessary to first make a general description of technical aspects of bolted joints. What really happens when tightening with torque wrench or with bolt tensioner is explained.

Initial losing behavior of pre-tightening force for threaded fastener during repeated tightening

Changing behavior of friction coefficient for high strength bolts during repeated tightening

Test on shear behavior of less-tightened high-strength bolted connections

The effect of tightening again on bolt loosening under transverse load: Experimental and finite element analysis

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

Analysis of Process Parameters Influencing Protuberance During Interference Fit Installation of Hi-lock Bolts

Experimental investigation of mechanical behavior of grade 8.8 and 10.9 small-sized (m14-m20) bolts with the thread into the bolt hole

Influence of Interference Fit Size on Hole Deformation and Residual Stress in Hi-Lock Bolt Insertion

Experimental Study of the Loosening of Threaded Fasteners with Transverse Vibration

Study on the fastening property of precision locknut under simulated dynamic impact loading with consideration of interference factors

The Tightening and Untightening Modeling and Simulation of Bolted Joints

Critical load determination for preventing rotational loosening in bolted joints under dynamic transverse loads

Effects of Different Friction Coefficients on Input Torque Distribution in the Bolt Tightening Process Based on the Energy Method

Finite element analysis of bolted joints under torsional loads

Three-dimensional finite element analysis of tightening and loosening mechanism of threaded fastener

Research on bolt pre-tightening and relaxation mechanism under transverse load

Research on the relationship between the tightening torque and the preload of composite bolted structures

Complex tribology of bolted assembly

Tightening performance analysis of bolted connection considering non-parallel contact

Optimal tightening process of bolted joints

Analysis of the Support Failure Mechanism Caused by Bolt Pre-Tightening Force Loss