Abstract:Threaded fasteners were developed long time (let’s remember that Archimedes – 287-212 BC – invented the water screw). Nowadays, bolted joints are used in almost all sectors of the industry. But in spite of having been an important machine part for centuries, problems may be encountered with them. They are so common that they are taken for granted and too often, not analyzed as deeply as it should be. The wrong tightening is one of the most frequent causes of ductile rupture and by far the most frequent cause of fatigue failure. The tightening operation is never easy. It is necessary to pay particular attention to the choice of the tightening tool, the process and the control method. The tightening operation may itself cause damage on parts. The tightening load must not be too low, or excessive or not equally distributed among the bolts. These three defects can even be made on the same bolted joint! This impacts badly the performance of the assembly and leads to a shorter lifespan. If insufficient precautions are taken, the real tightening preload on all the bolts will not fit well with the requirements and would be badly distributed. Consequently, the practical conditions are quite different from the hypothesizes which are taken for the initial calculations (analytics or FEM) at the design stage. Thus, the results of the calculations of bolted joints cannot be considered as accurate and reliable. Practically, there are several means to tighten a bolt. The two ways most frequently used are torque wrench and hydraulic bolt tensioner. Torque wrench involves exerting a torque to the bolt head or the nut. Hydraulic bolt tensioner applies a traction load directly on the bolt. It is well known that bolt tensioners give better accuracy and homogeneity in the final tightening load than the torque method, but the tension load applied with the tensioner must be higher than the final remaining tightening load. So, the paper focusses on the hydraulic tensioner to show how the tightening load can be obtained from the applied tension load and to propose a way to optimize and secure the tightening process. However, for the reasons above mentioned it appears necessary to first make a general description of technical aspects of bolted joints. What really happens when tightening with torque wrench or with bolt tensioner is explained.

Research on the relationship between the tightening torque and the preload of composite bolted structures

Analysis and determination of bolt tightening process factors for composite structures under multiple working conditions

Mechanical Behavior of Loose High-Strength Bolted Connections with Thin Sheet Steels

An improved 3D model of composite bolted joints with detailed thread structure and progressive damage analysis of realistic tightening process

Tightening performance analysis of bolted connection considering non-parallel contact

Influence of Interference Fit Size on Hole Deformation and Residual Stress in Hi-Lock Bolt Insertion

Test on shear behavior of less-tightened high-strength bolted connections

Effects of bolt preload relaxation on the mechanical performance of composite structures

Torsional and compressive properties of bolted joint under forward-reverse tightening

The Tightening and Untightening Modeling and Simulation of Bolted Joints

Research on bolt pre-tightening and relaxation mechanism under transverse load

Tightening Torque and Washer Size Effects on Bearing Strength of Fiber Metal Laminate Bolted-Joints

Investigation on the Progressive Damage and Bearing Failure Behavior of Composite Laminated Bolted Joints under Tension

Preload relaxation behavior and its influence on the mechanical performance of bolted carbon fiber‐reinforced thermoplastic sheet molding compound joints

An analytically improved four-stage model for single-lap torqued bolted joints accounting for preload relaxation

Optimal tightening process of bolted joints

Magnetostrictive Composite Bolt Fastening Characteristics and Internal Axial Force

Modeling and free vibration analysis for bolted composite plate under inconsistent pre-tightening condition

Influence of creep on preload relaxation of bolted composite joints: Modeling and numerical simulation

Three-dimensional finite element analysis of tightening and loosening mechanism of threaded fastener

Tensile tests and strength estimation for double-lap single-bolt j oints in T800 carbon fiber reinforced composites