Abstract:To improve the transmission performance and preparation of a transducer array, two planar array transducers based on connected 1–3 piezoelectric composites as a matrix were designed. Each transducer contained 25 array elements with a gap of 1 mm between them. The length, width and height of each array element were 1 mm, 26 mm and 5 mm, respectively. Two kinds of array transducers were tested through finite element simulation and experiments. The array transducer prototype was fabricated based on two kinds of composite materials, and the fabrication cycle was short. Our results show that the maximum transmission voltage response of the two-phase 1–3 full array driver is up to 179 dB at 200–400 kHz and the acoustic radiation intensity can be increased by up to 22% compared with the traditional splicing transducer array. It is suitable for short-range target positioning and measurement. Moreover, in the single element mode, the beam of the three-phase 1–3 transducer has no sidelobe and a single element −3 dB beam width of up to 91°. Furthermore, the beam width of the two-phase 1–3 type is 54°, and the acoustic radiation breadth is improved by 40.6%. The three-phase 1–3 type array transducer has the characteristics of concentrated acoustic transmission energy of the whole array, and its −3 dB beam width is 3.5°. The beam width decreased by 12.5%, indicating that the three-phase 1–3 type transducer is suitable for short-range target detection and perception. The two array transducers have their own advantages in transmitting the voltage response and beam width, which must be selected on the basis of the requirements of practical applications.

Development and Performance Test of Piezoelectric Composite 5-Element Transducer Array

Study of 1-3-2 type piezoelectric composite transducer array

Development of Underwater Acoustic Transducer Using 1-3-2 Piezoelectric Composite

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Design of Planar Array Transducers Based on Connected 1–3 Piezoelectric Composites

Design and Fabrication of Air-Based 1-3 Piezoelectric Composite Transducer for Air-Coupled Ultrasonic Applications

Research and fabrication of bimetallic plate transducer based on finite element analysis

Modified 1-3 ceramic/epoxy piezocompsite and cylinder array transducer

Design, Fabrication, and Characterization of 1-3 Piezoelectric Composite Air-Coupled Ultrasonic Transducers with Micro-Membrane Filter Matching Layer

Design And Fabrication Of A High-Frequency Single-Directional Planar Underwater Ultrasound Transducer

Design of Piezoelectric Ultrasonic Transducer Based on Doped PDMS

Simulation of 1-3 Piezoelectric Composite Cylindrical Transducer

Study on Underwater Performance of Underwater Transducer Manufactured by 1-1-3 Piezoelectric Composite

Research on 1-3 Piezocomposite Broad-Band Underwater Transducers

Design and Fabrication of 1-3 Piezoelectric Composite Material Air Coupled Ultrasonic Transducer

A Doubly-Curved Piezoelectric Composite with 1–3 Connectivity for Underwater Transducer Applications

A 300 Khz High-Frequency Underwater Transducer

Study on the cambered 1-3-2 piezocomposite material and transducer

Finite Element Analyses For Radial Piezoelectric Mode Laminated Transducer

Research, design, and analysis of a stacked piezoelectric metamaterial structured sensitive element

Fine‐Scaled Piezoelectric Ceramic/Polymer 2‐2 Composites for High‐Frequency Transducer