Abstract:Piezoelectric composite materials, combining the advantages of both piezoelectric materials and polymers, have been extensively used in ultrasonic transducers. However, the pitch size of radial array ultrasonic transducers normally exceeds one wavelength, which limits their performance. In order to minimize grating lobes of current radial transducers and then increase their imaging resolution, a 2.5 MHz 1-3 composite radial array transducer with 64 elements and 600 μm pitch was designed and fabricated by combining flexible circuit board and using a bending-and-superposition method. All the array elements were connected and actuated via the customized circuit board which is thin and soft. The kerf size is set to be 1/3 wavelength. PZT-5H/epoxy 1-3 composite was used as an active material because it exhibits an ultrahigh electromechanical coupling coefficient (kt = 0.74), a very low mechanical quality factor (Qm = 11), and relatively low acoustic impedance (Zc = 13.43 MRayls). The developed radial array transducer exhibited a center frequency of 2.72 MHz, an average −6 dB bandwidth of 36%, an insertion loss of 31.86 dB, and a crosstalk of −26.56 dB between the adjacent elements near the center frequency. These results indicate that the bending-and-superposition method is an effective way to fabricate radial array transducers by binding flexible circuit boards. Furthermore, the utilization of tailored flexible circuitry boards presents an effective approach for realizing reductions in crosstalk level (CTL).

Simulation of 1-3 Piezoelectric Composite Cylindrical Transducer

Mathematical Modelling of One-Dimensional Piezoelectric Transducers Based on Monoclinic Crystals

Modelling of Nonlinear Dynamics for Reciprocal Multi-Layer Piezoceramic Transducer Systems

Finite Element Analysis and Theoretical Model of Slotted Cymbal Composite Piezoelectric Transducer

Dynamic Behavior of Piezoelectric/Magnetostrictive Composite Hollow Cylinder

Parametric Analysis and Optimization of Radially Layered Cylindrical Piezoceramic/Epoxy Composite Transducers

An approximated 3-D model of cylinder-shaped piezoceramic elements for transducer design

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Study of 1-3-2 type piezoelectric composite transducer array

Design of Piezoelectric Ultrasonic Transducer Based on Doped PDMS

The Modeling Design and Analysis of Spherical-Cymbal Piezoelectric Transducer

Design of Radial Composite Longitudinal Vibration Piezoelectric Transducer Excited by Four Piezoelectric Stacks

Finite element simulation of ultrasonic standing wave fields inside cylindrical piezoelectric transducers

New 1-3 type piezoelectric composite material for kilohertz frequency range transducers

Fabrication of Radial Array Transducers Using 1-3 Composite via a Bending and Superposition Technique

Coupled vibration of a radially polarized piezoelectric cylinder with a co-axial elastic cylinder of varying height

Performance comparison of 2-1-3, 1-3 and 1-3-2 piezoelectric composite transducers by finite element method

An analytical model of a piezoelectric unimorph transducer with an aluminum cone

Analysis of electromechanical characteristics of the 1-3-2 piezoelectric composite and 1-3-2 modified structural material

High accuracy comsol simulation method of bimorph cantilever for piezoelectric vibration energy harvesting

Research on Effective Electric-Mechanical Coupling Coefficient of Sandwich Type Piezoelectric Ultrasonic Transducer Using Bending Vibration Mode