Abstract:New avenues for thermal energy storage (TES) need to be investigated due to the lack of competitiveness of concentrated solar power (CSP) technologies. Solutions must be found to replace molten salt tanks which have a major economic impact and are difficult to maintain due to corrosion problems. In this sense, concrete represented an attractive candidate by proving excellent sensible TES in CSP. However, its main phase, made of Portland cement (PC), has significant environmental consequences. The production of PC is known to emit high levels of polluting gases, particularly the CO2. It is estimated to be responsible for between 5% and 7% of the world's CO2 emissions, making it a major contributor to climate change. This work presents greener cementitious materials, made of alkaline cements and hybrids cements, to be used as alternative eco-friendly TES media in CSP plants. An experimental campaign is presented which shows that these eco-efficient materials can have better mechanical properties, than the ordinary PC mortar, when exposed to high temperatures, in addition, can offer improvements of their thermal properties (thermal conductivity or specific heat). Second part of the work is devoted to Finite Element simulations, with the aim to find the best configuration, in terms of selection of materials and geometry, which are more efficient as TES system. The work is showing the following advancements in CSP technology by using alternative eco-friendly binders: the installation volume can be reduced by 17%, compared to a molten salt tank, while the heat exchanger's surface area can be resized by 29%, compared to the reference system using PC. These improvements enable wider variations in CSP operational efficiency and dynamic capabilities and represent important progress towards developing more efficient and sustainable CSP technologies.

Experimental measurements and XCT based simulation of effective thermal conductivity of stacked ceramsites in molten-salt tank foundation

Experimental Study on Thermal Conductivity of Mixed Materials of Sand and Bentonite

Investigation on Heat and Mass Transfer Performance of Novel Composite Strontium Chloride for Sorption Reactors

Thermal Properties, Permeability and Compressive Strength of Highly Porous Accumulated Ceramsites in the Foundation of Salt Tank for Concentrate Solar Power Plants

Experimental and Simulation Study of Mn–Fe Particles in a Controllable-Flow Particle Solar Receiver for High-Temperature Thermochemical Energy Storage

Experimental Investigation of the Comprehensive Heat Transfer Performance of PCMs Filled with CMF in a Heat Storage Device

Investigation on Performance of Multi-Salt Composite Sorbents for Multilevel Sorption Thermal Energy Storage

Experimental Investigation and X-Ray Computed Microtomography Simulation on Thermal Physical Properties of Foundation Materials after Molten Salt Leakage in the Storage Tank

Study on the theoretical calculation method for the effective thermal conductivity of carbon nanotube composite molten salt for solar energy application

Measurement and Analysis of Thermal Conductivity of Ceramic Particle Beds for Solar Thermal Energy Storage

Thermal transport properties of composite phase change materials characterized by molten carbonate-ceramic date nucleus occupancy structure: A molecular dynamics study

Insights into the thermophysical properties and heat conduction enhancement of NaCl-Al2O3 composite phase change material by molecular dynamics simulation

Thermo-Mechanically Coupled Settlement and Temperature Response of a Composite Foundation in Complex Geological Conditions for Molten Salt Tank in Tower Solar Plants

Experimental and computational optimization of eco-friendly mortar blocks for high temperature thermal energy storage of concentrated solar power plants

Heat transfer characteristics and compatibility of molten salt/ceramic porous composite phase change material

Thermal Cycling Test of Solar Salt in Contact with Sustainable Solid Particles for Concentrating Solar Power (CSP) Plants

Experimental and Numerical Studies on Melting/solidification of PCM in a Horizontal Tank Filled with Graded Metal Foam

Comprehensive thermal energy storage analysis of ceramic foam-enhanced molten salt in a shell-and-tube unit

Experimental Study on Specific Heat of Concrete at High Temperatures and Its Influence on Thermal Energy Storage

Mechanical and Thermal Properties of Cement Composite Graphite for Solar Thermal Storage Materials

Experimental and Numerical Investigation of Temperature Distribution and Heat Loss of Molten Salt Tank Foundation at Different Scales