Abstract:This paper numerically investigates the effect of turbulence and journal misalignment on the lubrication characteristics of micro-grooved bearings with low-viscosity lubricant. The generalized average Reynolds equation satisfying the mass conservation cavitation algorithm is developed by integrating the average flow model proposed by Patir and Cheng, the Ng–Pan turbulent model, and the P- Θ model proposed by Elrod and Adams. With this model, the finite difference method is used in the numerical procedure. Moreover, the mathematical models of micro-grooves with different bottom shapes, that is, rectangle, isosceles triangle, left triangle, and right triangle, are given. The validity of the proposed model is verified by the comparisons with the published literature. Based on numerical simulation, the minimum film thickness, eccentricity ratio, attitude angle, maximum film pressure, friction torque, misalignment moment, film thickness, and pressure distributions under different external loads, rotational speeds, radial clearances, misalignment angles, and micro-groove parameters between models with and without turbulence and misalignment are comparatively analyzed. The numerical results reveal that turbulence may occur under heavy external load, high rotational speed, and large radius clearance. Concurrently, turbulence increases the minimum fluid film thickness and attitude angle, decreases the eccentricity ratio and friction torque, and enhances the bearing capacity. Furthermore, the larger misalignment angle results in the smaller minimum film thickness, eccentricity ratio and attitude angle, and the larger maximum film pressure, misalignment moment, and axial tilt of film pressure. Numerical simulations can provide theoretical guidance for the optimization of the geometrical parameters of micro-grooved bearings.

Improvement of Lubrication Performance of Water Lubricated Polymer Bearing Via Enlarged Axial End Bearing Diameter

Investigations of the Micro Surface Shape for the Gear-Shaft/journal-bearing Interface in Water Hydraulic Internal Gear Pumps

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Theoretical and experimental exploration into the fluid structure coupling dynamic behaviors towards water-lubricated bearing with axial asymmetric grooves

Research the lubrication characteristics on the modified main thrust roller of the slewing bearings

Design and Fabrication of the Lubricating Dimple of the Headface Sliding Bearing with Phyllotactic Pattern

Analysis of mixed lubrication of RV reducer turning arm roller bearing

Optimization transient wear and contact performances of water-lubricated bearings under fluid-solid-thermal coupling condition using profile modification

Study on the tribological performance of self-lubricating thrust ball bearings with different embedded features

Modelling and performance improvement of an annular grooved thrust air bearing

A novel method for bearing lubrication enhancement via the inner ring groove structure

Tribological and Vibration Properties of Three Different Polymer Materials for Water-Lubricated Bearings

Numerical analysis of the lubricating gap between the gear shaft and the journal bearing in water hydraulic internal gear pumps

Analysis of piston-pin lubrication considering the effects of structure deformation and cavitation

Film-Thickness Identification Method and Lubrication Characteristic Experiment of Full-Size Water-Lubricated Stern Bearing under Offset Load

A study on improving friction and wear performance of bearing bush in radial piston hydraulic motor

Lubrication mechanism and characteristics of aerostatic bearing with close-spaced micro holes

Effect of hollow-tube structure on the tribological performance of biomimetic water-lubricated bearing material

Vibration Reduction Performance of Damping-Enhanced Water-Lubricated Bearing Using Fluid-Saturated Perforated Slabs

Investigation on the lubrication characteristics of low-viscosity lubricated micro-grooved bearings considering turbulence and misalignment

On the lubrication performance of journal bearing coupled with the axial movement of journal