Abstract:The recycling of waste plastics is of considerable significance with environmental and economic benefits, while available separation approaches have been considered as a major bottleneck for its widespread application. Thus, we proposed a simple method, flotation along with surface modification, to separate waste acrylonitrile-butadienestyrene and polyvinylchloride mixtures. Single-factor experiment was conducted to determine the critical parameters in surface modification. Surface response methodology using Box-Behnken Design was performed to optimize separation performance. The quadratic models were generated to predict the floatability of acrylonitrile-butadienestyrene and the difference between the floatability of polyvinylchloride and acrylonitrile-butadienestyrene. The model was also utilized to determine optimized conditions by desirability approaches. The optimized conditions were: concentration = 0.18 M, temperature = 75.00 degrees C, treatment time = 11.50 min along with stirring rate = 200 rpm. The efficient separation of acrylonitrile-butadienestyrene and polyvinylchloride was achieved, yielding recovery of 98.40% and purity of 98.43%. The experimental responses well agreed with predicted values, demonstrating the accuracy of the prediction model. The formed hydrophilic groups, coated iron oxide, and signs of corrosion were confirmed as the major mechanism for the selective surface hydrophilization of acrylonitrile-butadienestyrene. Consequently, this method is feasible for separation of waste acrylonitrile-butadienestyrene and polyvinylchloride mixtures, and can be expected to promote the sustainable recycling of waste plastics. (C) 2019 Elsevier Ltd. All rights reserved.

Structure Optimization of Separating Nozzle for Waste Plastic Recycling

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Analysis of gas-solid two-phase flow and structure optimization of mobile shot blasting machine recovery device

Optimal Design of Steam Ejector by Computational Fluid Dynamics Simulation

Optimizing Green Ferrate (VI) Modification Towards Flotation Separation of Waste Polyvinylchloride and Acrylonitrile-Butadiene-styrene Mixtures.

Exploring flotation separation of polycarbonate from multi-microplastic mixtures via experiment and numerical simulation

Experimental research and numerical analysis for effect of drainage structure on separation performance and the "blockage" of fluid in nozzle

Design of Nozzle in Water Jet for Cutting Waste Steel and Its Experiments

Design of water nozzle shape and structure optimization for eccentric injection mandrel in water injection wells

Modeling and Optimizing of Producing Recycled PET from Fabrics Waste Via Falling Film-Rotating Disk Combined Reactor

Optimization of Structural Parameters for Corrugated Plates Separator With Single Scoop

Optimization of Surface Treatment Using Sodium Hypochlorite Facilitates Coseparation of ABS and PC from WEEE Plastics by Flotation

Simulation and Optimization of the Nozzle Section Geometry for a Suspension Abrasive Water Jet

The Research Of Structural Optimization On Diesel Engine Injection Nozzle

The Research of Technical Solutions of the New Plastic Particles 3D Printer

Parameters optimization for decontamination and fine physical regeneration pathways of polypropylene plastics from waste lunchboxes

Numerical Optimization of Waste Baffle Structure Parameters of Gas Centrifuge

Analysis and Manipulation of the Separation Zone in an Overexpanded Combined Exhaust Nozzle

Structure optimization of submerged water jet cavitating nozzle with a hybrid algorithm