Abstract:High temperature REBCO superconducting tapes are very promising for high-field magnets. Under high magnetic fields there are high electro-mechanical forces, and thus concern for mechanical damage. Due to large screening currents and composite structure of the tape, the mechanical design of these magnets is not straightforward. In addition, many contemporary designs use insulated winding. In this work we develop a novel two-dimensional axisymmetric finite element tool programmed in MATLAB that assumes the displacement field within linear elastic range. The stack of pancakes and a large number of REBCO tape turns are approximated as an an-isotropic bulk hollow cylinder. Our results agree with uni-axial stress experiments in literature, validating the bulk approximation. Here, we study the following configuration. The current is first ramp up to below the critical current and we calculate the screening currents and the forces that they cause using the MEMEP model. As a case study, 32 T REBCO superconductor magnet, is taken and simulated numerically. We have done complete mechanical analysis of the magnet by including the axial and shear mechanical quantities for each pancake unlike previous work where only radial and circumferential quantities are focused. Effect on mechanical quantities without screening current is also calculated and compared. It is shown that including screening current induced field strongly affect the mechanical quantities, specially the shear stress. The latter might be the critical quantity for certain magnet configurations. Additionally, in order to overcome high stresses, a stiff over banding of different material is considered and numerically modelled which significantly reduces the mechanical stresses. The FE based model developed is efficient to calculate the mechanical behaviour of any general superconductor magnet and its devices.

Decay of Trapped Magnetic Field in Stacks of YBCO Coated Conductors Subjected to Traveling Magnetic Waves

Experiments and Simulation of Electromagnetic Properties in an HTS Knitted Tape Stack

Simulation And Analysis Of An (Re)Bco Tape Stack Magnet Under The Pulsed Field Magnetization

Angular dependence of direct current decay in a closed YBCO double-pancake coil under external AC magnetic field and reduction by magnetic shielding

Numerical Investigation of Critical Current and Magnetization Loss Effect for Twisted Stacked Tape Cable Considering Field-Angle Dependency and Mechanical Torsion Degradation

Simulation of Stacks of High Temperature Superconducting Coated Conductors Magnetized by Pulsed Field Magnetization Using Controlled Magnetic Density Distribution Coils

Investigation of the Slotting Effect on the Magnetisation of Trapped Field Stacks in a Superconducting Machine

Remagnetization of bulk high-temperature superconductors subjected to crossed and rotating magnetic fields

Effect of Dynamic Resistance on AC Loss in Stacked Superconducting Tapes

A Pulsed Current Charging Mechanism for High Temperature Superconducting Magnets

Simulation and experiments of Stacks of High Temperature Superconducting Coated Conductors Magnetized by Pulsed Field Magnetization with Multi-Pulse Technique

Testing and Comparison of Levitation Forces and Rotational Friction in Different Superconducting Tape Stacks

Behaviour Prediction of Closed-loop HTS coils in Non-Uniform AC fields

The Flux Pumping Behavior of High Temperature Superconducting Tapes with a Linearly Moving Electromagnet

Critical Current Degradation of YBCO Tape with Different Stabilizing Layers under Cyclic Mechanical Strains

Numerical Modeling of Normal Zone Propagation and Heat Transfer in a Superconducting Composite Tape

Assessment of Critical Factors Affecting the Performance of Trapped Field Magnets Using Thin Film Superconductor Tapes

Electro-Mechanical Behavior In Arrays Of Superconducting Tapes

Optimisation and Loss Analyses of Pulsed Field Magnetisation in a Superconducting Motor with Cryocooled Iron Cores

Modelling the mechanics of 32 T REBCO superconductor magnet using numerical simulation

Vortex Shaking Study of REBCO Tape with Consideration of Anisotropic Characteristics.