Abstract:A back-to-back reentrant cavity resonator (BTB RECR) in substrate integrated waveguide (SIW) configuration is integrated with a negative resistance oscillation (NRO) circuit to implement an SIW BTB RECR NRO-based active sensor for self-sustained sensing application. The dependence of sensitivity on the polarization between the dielectric sample and the induced E-field of the passive SIW BTB RECR is investigated to obtain sensitivity as high as possible. A multitask LabVIEW-based real-time test system, which can avoid disassembly and ensure the reliability of the measured results, is built up to selectively measure for transmission coefficient S $_{{21}}$ and frequency spectrum through a microwave switch. During the process of real-time replacement of deionized (DI) water reference solution with NaCl solution in dielectric sensing channel, the in-between real-time recorded oscillation frequency is cleverly used as the frequency-modulated (FM) input signal to the delay-line-based frequency demodulator and is transferred to in-phase V $_{{\text{I}}}$ and quadrature V $_{{\text{Q}}}$ dc voltages. Then, the modulated V $_{{\text{I}}}$ and V $_{{\text{Q}}}$ dc voltages are postprocessed into phase angle by using arctangent algorithm, and the phase angle in stable convergence state is finally used as response parameter for self-sustaining measurement for the concentration of NaCl solution. The NRO-based active sensor demonstrates a phase angle self-shift noise of 7.8 $^{\circ}$ and a high-resolution detection to NaCl solution at low concentration level from 2.5 to 80 mM/L and high concentration level from 100 to 800 mM/L. The measured minimum detectable lower limit concentration is 2.5 mM/L, and maximum sensitivity is 40 kHz/mM $\cdot$ L $^{{-1}}$ (0.31 $^{\circ}$ /mM $\cdot$ L $^{{-1}}$ ).

A surface acoustic wave device for water impurity levels monitoring by measuring signal-to-perturbation ratios

An AlN Based SAW Device for Detection of Impurities in Water Based on Measuring the Signal-to-Noise Ratio

Study of a novel surface acoustic wave liquid detection system

Investigating Effectiveness of Sensor Placement Strategies in Contamination Detection within Water Distribution Systems

Real-Time Water Quality Monitoring with Chemical Sensors

A Novel Serial High Frequency Surface Acoustic Wave Humidity Sensor

Non-contact surface water conductivity measurement system

Surface Plasmon Resonance for Water Pollutant Detection and Water Process Analysis

Development Of Automatic Dual-Channel Spr Detecting Instrument

Multilayered Surface Plasma Resonance Waveguide Sensing Device

Integrated Water Quality Monitoring System with Ph, Free Chlorine, and Temperature Sensors

A Novel Chemical Sensor with Multiple All-Solid-state Electrodes and Its Application in Freshwater Environmental Monitoring.

Few-Layer Si and WS2-Based Surface Plasmon Resonance Sensor for Water Salinity Concentration Detection: Theoretical Insight

A High-Frequency and Real-Time Ground Remote Sensing System for Obtaining Water Quality Based on a Micro Hyper-Spectrometer

Modeling and Testing of a Highly Sensitive Surface Acoustic Wave Pressure Sensor for Liquid Depth Measurements

Ultrasonic Sensor and In-Situ Correction for the Monitor of Indistinct Interface Level

A novel method of detecting contamination state on the hydrophobic surface

Distilling Determination of Water Content in Hydraulic Oil with a ZnO/glass Surface Acoustic Wave Device

Real-time monitoring of airborne molecular contamination on antireflection silica coatings using surface acoustic wave technology

A discovery of an ultra-pure water detection method based on water mark

Oscillation-Based Active Sensor on SIW Reentrant Cavity Resonator for Self-Sustained Ultralow Concentration Detection to Saline Solution