Abstract:On-site simultaneous quantification of multiple contaminants in a water body is challenging, especially for parameters requiring complicated chemical reactions to measure such as Chemical Oxygen Demand (COD), ammonia nitrogen, and phosphate. A novel disposable multiplexed microfluidic device has been developed herein that allows the quantitative detection of up to five parameters at once. Solid reagent rather than commonly used liquid reagent was used to ensure long shelf life, and a "flow to dissolve" mechanism was provided accordingly for the thorough dissolution and mixing of a solid reagent on chip. Samples from river water and industrial wastewater were tested using the microfluidic chip, showing less than 15% deviation from results acquired with the traditional standard method. The test time though was only 1/6 of that required by the traditional method. In addition, the feasibility of using a smartphone to collect the colorimetric signal was discussed, and a data analysis method was provided for quantification purposes. The combination of the multiplexed chip and smartphone imaging provides a convenient and practical way to obtain accurate information on the water quality within a short period of time without the use of any sophisticated instruments.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssensors.0c00775?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssensors.0c00775</a>.SI Figure 1 is the absorbance spectrum of COD detection solution at different target concentrations. SI Table 1 is the concentration of targets used in the cell phone imaging experiments. SI Table 2 is the standard substance and detection chemistry for each parameter. MATLAB code for R, G, and B value calculation is also provided. (<a class="ext-link" href="/doi/suppl/10.1021/acssensors.0c00775/suppl_file/se0c00775_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Integrated Water Quality Monitoring System with Ph, Free Chlorine, and Temperature Sensors

Fully Integrated, Simple, and Low-Cost Electrochemical Sensor Array for in Situ Water Quality Monitoring

A Low-Cost Multi-Parameter Water Quality Monitoring System

Real-Time Water Quality Monitoring with Chemical Sensors

Multiplex Analysis of Fundamental Surface Water Quality Indicators by Multichannel Electrochemical Device Combined with MFCSC Model

A Novel Chemical Sensor with Multiple All-Solid-state Electrodes and Its Application in Freshwater Environmental Monitoring.

A Multi-Parameter Integrated Chip System For Water Quality Detection

Fabrication of a Miniature Multi-Parameter Sensor Chip for Water Quality Assessment

An On-Line Multiparametric Water Quality Monitoring System Based on Visible Spectrophotometry

A High-Frequency and Real-Time Ground Remote Sensing System for Obtaining Water Quality Based on a Micro Hyper-Spectrometer

Development and Calibration of a Microfluidic, Chip-Based Sensor System for Monitoring the Physical Properties of Water Samples in Aquacultures

Real-time in situ sensing of multiple water quality related parameters using micro-electrode array (MEA) fabricated by inkjet-printing technology (IPT)

Microsensors and Systems for Water Quality Determination

A Disposable Multiplexed Chip for the Simultaneous Quantification of Key Parameters in Water Quality Monitoring

Multiparameter water quality monitoring system based on ZigBee

Research on a Miniature Multiparameter Water Quality Sensor Chip and a System with a Temperature Compensation Function.

Design of a Water Environment Monitoring System Based on Wireless Sensor Networks

Low-cost IoT based system for lake water quality monitoring

STM32 BASED WATER QUALITY MONITORING SYSTEM

TEMPSENSE: LoRa Enabled Integrated Sensing and Localization Solution for Water Quality Monitoring

Multiparameter Water Quality Monitoring System for Continuous Monitoring of Fresh Waters