Abstract:We demonstrate for the first time the controlled Sn-doping in TiO(2) nanowire (NW) arrays for photoelectrochemical (PEC) water splitting. Because of the low lattice mismatch between SnO(2) and TiO(2), Sn dopants are incorporated into TiO(2) NWs by a one-pot hydrothermal synthesis with different ratios of SnCl(4) and tetrabutyl titanate, and a high acidity of the reactant solution is critical to control the SnCl(4) hydrolysis rate. The obtained Sn-doped TiO(2) (Sn/TiO(2)) NWs are single crystalline with a rutile structure, and the incorporation of Sn in TiO(2) NWs is well controlled at a low level, that is, 1-2% of Sn/Ti ratio, to avoid phase separation or interface scattering. PEC measurement on Sn/TiO(2) NW photoanodes with different Sn doping ratios shows that the photocurrent increases first with increased Sn doping level to >2.0 mA/cm(2) at 0 V vs Ag/AgCl under 100 mW/cm(2) simulated sunlight illumination up to ~100% enhancement compared to our best pristine TiO(2) NW photoanodes and then decreases at higher Sn doping levels. Subsequent annealing of Sn/TiO(2) NWs in H(2) further improves their photoactivity with an optimized photoconversion efficiency of ~1.2%. The incident-photon-to-current conversion efficiency shows that the photocurrent increase is mainly ascribed to the enhancement of photoactivity in the UV region, and the electrochemical impedance measurement reveals that the density of n-type charge carriers can be significantly increased by the Sn doping. These Sn/TiO(2) NW photoanodes are highly stable in PEC conversion and thus can serve as a potential candidate for pure TiO(2) materials in a variety of solar energy driven applications.

Colloidal synthesis of SnS nanocrystals with dimension-dependent photoelectrochemical properties

Enhanced Photoelectrochemical Water Splitting with Template-Free Electrodeposition of SnS Nanorods Photoelectrode

Fabrication of 2D SnS2 nanoflake photoanodes by a two-step process

Constructing a Two-Dimensional SnWO 4 Nanosheet Array Film for Enhanced Photoelectrochemical Performance

Facet-Dependent SnS Nanocrystals As the High-Performance Counter Electrode Materials for Dye-Sensitized Solar Cells

Production of SnS 2 Nanostructure as Improved Light-Assisted Electrochemical Water Splitting.

Facile Synthesis of Tin Monosulfide Nanosheets Via Physical Vapour Deposition and Their Near-Infrared Photoresponse

Controlled Sn-doping in TiO2 Nanowire Photoanodes with Enhanced Photoelectrochemical Conversion.

Colloidal synthesis of metastable zinc-blende IV-VI SnS nanocrystals with tunable sizes.

General In Situ Photoactivation Route with IPCE over 80% toward CdS Photoanodes for Photoelectrochemical Applications

Synergistic effect of atomic layer deposition-assisted cocatalyst and crystal facet engineering in SnS2 nanosheet for solar water oxidation

Chemical Bath Deposition of SnS Nanosheet Thin Films for FTO/SnS/CdS/Pt Photocathode

Crystal Facet-Controlled Efficient SnS Photocathodes for High Performance Bias-Free Solar Water Splitting

Nanowire Morphology Control in Sb Metal-derived Antimony Selenide Photocathodes for Solar Water Splitting

Colloidal Tin Sulfide Nanosheets: Formation Mechanism, Ligand-mediated Shape Tuning and Photo-detection

SnS x Se 1– x /Ag Nanosheet Thin Films for Solar Energy Water Splitting

Synthesis of CuI/Sn-ZnO Based p-n Heterojunction Photoanode for Photoelectrochemical Water Splitting

Uniform carbon-coated CdS core–shell nanostructures: synthesis, ultrafast charge carrier dynamics, and photoelectrochemical water splitting

Simultaneous Modulation of Interface Reinforcement, Crystallization, Anti-Reflection, and Carrier Transport in Sb Gradient-Doped SnO2 /Sb2 S3 Heterostructure for Efficient Photoelectrochemical Cell

Ligand-mediated synthesis of colloidal Cs2SnI6 three-dimensional nanocrystals and two-dimensional nanoplatelets

Cu(2)ZnSnS(4)-Pt and Cu(2)ZnSnS(4)-Au Heterostructured Nanoparticles for Photocatalytic Water Splitting and Pollutant Degradation.