Investigation of the structure and magnetic properties of Sn substituted Li-Zn ferrites fabricated by sol–gel process

Hao-ming Zhang,Zhi Wang,Jia-jia Pei,Yu Gao
DOI: https://doi.org/10.1007/s10971-019-04978-5
2019-01-01
Journal of Sol-Gel Science and Technology
Abstract:A series of Sn doped Li-Zn ferrite powders with composition of Li (0.2+0.5 x ) Zn 0.6 Sn x Fe (2.2−1.5 x ) O 4 ( x = 0.00, 0.02, 0.04, 0.06, and 0.08) are synthesized by sol–gel process. The ring-shaped bulk samples of all compositions are obtained by sintering at 950 °C for 3 h, and all the structural and magnetic measurements were carried out on the sintered bulk samples. X-ray diffraction (XRD) patterns confirmed the formation of single-phase spinel structure when x ≤ 0.06 and the second phase of SnO 2 at x = 0.08. Field emission scanning electron micrograph (FE-SEM) is used to observe the surface morphology of the bulk samples and particle sizes ( D SEM ). Micrograph of the sample for x = 0.08 shows many small particles appearing on the surface of the aggregation bulk samples. Vibrating sample magnetometer (VSM) is employed to study the saturation magnetization ( M s ) and coercivity ( H c ). The M s displays a downtrend with the increasing of doping concentration and all samples have a lower coercivity of less than 30 Oe. Initial permeability ( μ i ) and Curie temperature ( T c ) are measured in a furnace using HP4294A impedance analyzer. The μ i increases with the Sn 4+ concentration until x = 0.06 and the T c decreases with the Sn 4+ concentration. The cation distribution estimated from XRD pattern and magnetic properties analyses suggest that Li + ions appear in the tetrahedral sites with increasing of Sn 4+ and Li + contents.
What problem does this paper attempt to address?