Chemical Deactivation of Cu-SAPO-18 Deno(x) Catalyst Caused by Basic Inorganic Contaminants in Diesel Exhaust

Shujun Ming,Lei Pang,Chi Fan,Wen Guo,Yahao Dong,Peng Liu,Zhen Chen,Tao Li

DOI: https://doi.org/10.1016/s1872-2067(19)63312-7

2019-01-01

Abstract:Contaminants (K, Na, Ca, and Mg) were introduced into Cu-SAPO-18 via incipient wetness impregnation to investigate their effect on the selective catalytic reduction of NOx with NH3 (NH3-SCR) over Cu-SAPO-18. After the introduction of contaminants into Cu-SAPO-18, the quantity of acidic sites and Cu2+ species in catalyst decreases owing to the replacement of H+ and Cu2+ by K+, Na+, Ca2+, and Mg2+. Furthermore, the loss of isolated Cu2+ induces the generation of CuO and CuAl2O4-like phases, which causes further loss in the Brunauer-Emmett-Teller surface area of the catalyst. Consequently, the deNOx performance of the contaminated Cu-SAPO-18 catalysts drops. Such decline in NH3-SCR performance becomes more pronounced by increasing the contaminant contents from 0.5 to 1.0 mmol/gcatal. In addition, the deactivation influence of the contaminants on Cu-SAPO-18 is presented in the order of K> Na > Ca > Mg, which is consistent with the order of reduction of acidic sites. To a certain degree, the effect of the acidic sites on the deactivation of Cu-SAPO-18 might be more significant than that of isolated Cu2+ and the catalyst framework. Moreover, kinetic analysis of NH3-SCR was conducted, and the results indicate that there is no influence of contaminants on the NH3-SCR mechanism.