Abstract:With the raise of resolution, optical payloads are becoming increasingly sensitive to satellite jitter. An approach where the entire spacecraft is pointed with great accuracy requires sophisticated and expensive bus design. In an effort to lower the overall cost of space missions that require highly stable line-of-sight pointing, a method of separating the bus and the payload with low frequency isolators is proposed. This isolation system can block the transmission of disturbance and allow relatively large bus motion. However, if the isolator is linear then there is a trade-off between isolation and static deflection as the launch and the on-orbit stage have difference requirements on the isolation frequency. Otherwise, an extra locking system should be appended to protect the payload before getting into orbit, as the STABLE isolation system[1] and the MIM isolation system[2] did. To overcome this limitation, an alternative approach is to design a nonlinear isolator with high-static stiffness during launch and low dynamic stiffness on orbit. Several specially designed nonlinear isolators have achieved low dynamic stiffness with large static load capacity. Virgin[3] considered a structure made from a highly deformed elastic element to achieve a softening spring. Platus[4] exploited the buckling of beams under axial load in a specific configuration to achieve a negative stiffness in combination with a positive stiffness, and hence low-dynamic stiffness. Others have achieved the same by connecting linear springs with positive stiffness in parallel with elements of negative stiffness[5]~[7]. In the present study, a bifunctional isolator has been developed for optical payloads. The isolator have good performance both during launch and on orbit because of its specially designed nonlinear stiffness and damping. The isolator works in a linear part with low stiffness and small damping ratio under the micro-vibration and microgravity on orbit. The transmissibility requirement and the displacement restriction during launch are satisfied by tuning the nonlinear stiffness and damping parameters. A group of sample isolators are designed tested both statically and dynamically.

Performance Enhancement of Disturbance-Free Payload with a Novel Design of Architecture and Control

Relative Motion Dynamics Modeling and Control of DFP Vibration Isolation Spacecraft

Dynamic Modeling and Control of Disturbance-Free Payload Spacecraft.

Modeling and Pointing Performance Analysis of Disturbance-Free-Payload System with Flexible Umbilical Connection

Vibration Isolation and Dual-Stage Actuation Pointing System for Space Precision Payloads

Modeling and Micro-vibration Control of Flexible Cable for Disturbance-Free Payload Spacecraft

Hybrid Passive/Active Vibration Control of a Loosely Connected Spacecraft System

Modeling and Collision Avoidance Control for the Disturbance-Free Payload Spacecraft

Dynamics and Control of a Bio-Inspired Stewart Platform

Prescribed Performance Based Adaptive Model-Free Control for Highly Flexible Spacecraft Detumbling Rotating Satellites

Passive Impact/vibration Control and Isolation Performance Optimization for Space Noncooperative Target Capture

Experiments on Active Precision Isolation with A Smart Conical Adapter

Design and Simulation of an Active Vibration Isolator Based on Pneumatic-Electromagnetic Hybrid Driving

Micro-vibration control of spaceborne payload with smart parallel struts

Vibration Suppression of a Large Flexible Spacecraft for On-Orbit Operation

Design and Experimental Study of a Hybrid Micro-Vibration Isolation System Based on a Strain Sensor for High-Precision Space Payloads

Vibration Suppression of Optical Payload Based on Parallel Manipulator

Research on Control of Stewart Platform Integrating Small Attitude Maneuver and Vibration Isolation for High-Precision Payloads on Spacecraft

Dynamic Modeling of Relative Motion for Disturbance-Free-Payload Spacecraft

Parameter design and experimental study of a bifunctional isolator for optical payload protection and stabilization

Vibration Isolation Control Performance for an Innovative 3-DOF Parallel Stabilization Platform