Abstract:Centrifugal granulation technology using a spinning cup opens a potential way to recycle steel slag that is currently difficult to reuse. The objective of this research was to study the flow characteristics of a molten slag–metal mixture that was produced during smelting reduction in molten steel slag, passing over a spinning cup, so as to explore the feasibility of using centrifugal granulation technology to treat the steel slag. This was achieved by developing and implementing a computational fluid dynamics (CFD) model that incorporated free-surface multiphase flow to predict the thickness of the liquid slag film at the edge of the spinning cup (slag film thickness for short), which was an important parameter for estimating the size of the slag particles resulting from centrifugal granulation of the molten slag–metal mixture. The influences of various relevant parameters, including spinning cup diameter, slag feeding rate, cup spinning speed, etc., on the slag film thickness were analyzed. Additionally, hot experiments on centrifugal granulation of a molten slag–metal mixture were conducted to verify the results of the numerical simulations. The experimental results indicated a progressive reduction in the Sauter mean diameter of the slag particles as the metallic iron content in the slag increased. Specifically, when the iron content rose from 5% to 15% at a cup spinning speed of 2500 RPM, the Sauter mean diameter decreased by 13.77%. The numerical simulation results showed that the slag film thickness had a positive relationship to the slag feeding rate but a negative relationship to the spinning cup diameter and the cup spinning speed. Furthermore, the ratio between the mean slag particle diameter and the slag film thickness decreased nearly linearly with the increase in the metallic iron content in slag, with the average ratio being approximately 4.25, and this relationship was useful for estimating the slag particle size from the slag film thickness. Therefore, the present research results can provide theoretical guidance for the industrial application of spinning cup centrifugal granulation technology to effectively treat and recycle steel slags.

Experimental Investigation on Particles Characteristics in Molten Aluminum Ligament Granulation for Waste Energy Recovery

Analogue Experimental Investigation on Ligament Granulation of Molten Slag in Various Rotary Disk Configurations for Waste Energy Recovery

High-temperature Analogy Experimental Investigation on Dry Granulating Characteristic of Rotating Disk for Waste Heat Utilization of Molten Slag

Experimental Investigation of Slag Particles of Ligament Mode Disintegration in Spinning Disk Atomizing

Influence of Rotary Disk Configurations on Droplets Characteristics in Molten Slag Granulation for Waste Heat Recovery

Ligament-type Granulation of Molten Slag in Different Rotary Disk Configurations

Experimental investigation on granulation characteristics and waste heat recovery of molten slag in gas quenching dry granulation technique

Ligament Mode Disintegration of Liquid Film at the Rotary Disk Rim in Waste Heat Recovery Process of Molten Slag

Research status of centrifugal granulation, physical heat recovery and resource utilization of blast furnace slags

Theoretical Analysis of Free-Surface Film Flow on the Rotary Granulating Disk in Waste Heat Recovery Process of Molten Slag

Centrifugal granulation experimental study of molten blast furnace slag by rotary disk

Prediction on particle size characteristics of high-temperature liquid blast furnace slag in a centrifugal granulation process

Investigation of circumferential distribution of slag deposited on slag screen of Shell coal gasifier

Optimizing heat transfer and solidification crystallization in dry granulation of blast furnace slag

Flow Characteristics of the Liquid Film During Centrifugal Granulation of Liquid Slag on the Surface of Rotary Cup

Cooling and phase evolution of a molten blast furnace slag particle

Computational Fluid Dynamics Numerical Simulation on Flow Behavior of Molten Slag–Metal Mixture over a Spinning Cup

Granulation performance by hybrid centrifugal-air blast technique for treatment of liquid slag

Modelling the film fragmentation of industrial-scale centrifugal granulation of high-temperature molten slag

Experimental Investigation and Modeling of Cooling Processes of High Temperature Slags

Numerical Simulation of Heat Transfer of Roller Slag in Centrifugal Preparation of Inorganic Fiber