Abstract:Centrifugal granulation technology using a spinning cup opens a potential way to recycle steel slag that is currently difficult to reuse. The objective of this research was to study the flow characteristics of a molten slag–metal mixture that was produced during smelting reduction in molten steel slag, passing over a spinning cup, so as to explore the feasibility of using centrifugal granulation technology to treat the steel slag. This was achieved by developing and implementing a computational fluid dynamics (CFD) model that incorporated free-surface multiphase flow to predict the thickness of the liquid slag film at the edge of the spinning cup (slag film thickness for short), which was an important parameter for estimating the size of the slag particles resulting from centrifugal granulation of the molten slag–metal mixture. The influences of various relevant parameters, including spinning cup diameter, slag feeding rate, cup spinning speed, etc., on the slag film thickness were analyzed. Additionally, hot experiments on centrifugal granulation of a molten slag–metal mixture were conducted to verify the results of the numerical simulations. The experimental results indicated a progressive reduction in the Sauter mean diameter of the slag particles as the metallic iron content in the slag increased. Specifically, when the iron content rose from 5% to 15% at a cup spinning speed of 2500 RPM, the Sauter mean diameter decreased by 13.77%. The numerical simulation results showed that the slag film thickness had a positive relationship to the slag feeding rate but a negative relationship to the spinning cup diameter and the cup spinning speed. Furthermore, the ratio between the mean slag particle diameter and the slag film thickness decreased nearly linearly with the increase in the metallic iron content in slag, with the average ratio being approximately 4.25, and this relationship was useful for estimating the slag particle size from the slag film thickness. Therefore, the present research results can provide theoretical guidance for the industrial application of spinning cup centrifugal granulation technology to effectively treat and recycle steel slags.

Modelling the film fragmentation of industrial-scale centrifugal granulation of high-temperature molten slag

Optimizing heat transfer and solidification crystallization in dry granulation of blast furnace slag

Computational Fluid Dynamics Numerical Simulation on Flow Behavior of Molten Slag–Metal Mixture over a Spinning Cup

Numerical Simulation of the Slag Granulation Process in Gas Quenching Under Multi-influencing Factors

Prediction on particle size characteristics of high-temperature liquid blast furnace slag in a centrifugal granulation process

Flow Characteristics of the Liquid Film During Centrifugal Granulation of Liquid Slag on the Surface of Rotary Cup

Investigation of circumferential distribution of slag deposited on slag screen of Shell coal gasifier

Theoretical Analysis of Free-Surface Film Flow on the Rotary Granulating Disk in Waste Heat Recovery Process of Molten Slag

Cooling and phase evolution of a molten blast furnace slag particle

A hybrid cooling system to enable adhesion-free heat recovery from centrifugal granulated slag particles

Granulation performance by hybrid centrifugal-air blast technique for treatment of liquid slag

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Simulation of primary breakup of molten slag in the gas quenching dry granulation process

Research status of centrifugal granulation, physical heat recovery and resource utilization of blast furnace slags

Unraveling the role of chemical composition in the critical cooling rate of high-temperature CMAS slag

High-temperature Analogy Experimental Investigation on Dry Granulating Characteristic of Rotating Disk for Waste Heat Utilization of Molten Slag

Simulation of Motion and Heat Transfer Characteristics of Blast-Furnace Slag Particles in a Cyclone Separator

Ligament Mode Disintegration of Liquid Film at the Rotary Disk Rim in Waste Heat Recovery Process of Molten Slag

Experimental Investigation of Slag Particles of Ligament Mode Disintegration in Spinning Disk Atomizing

Analogue Experimental Investigation on Ligament Granulation of Molten Slag in Various Rotary Disk Configurations for Waste Energy Recovery

Centrifugal-Granulation-Assisted thermal energy recovery towards low-carbon blast furnace slag treatment: State of the art and future challenges