Transmission Power of Homemade Chirped and Tilted Fiber Bragg Grating on 25 m/400 m Fiber Exceeding 4 kW
Wang Meng,Tian Xin,Zhao Xiaofan,Ye Yun,Rao Binyu,Xi Xiaoming,Wang Xiaolin,Chen Zilun,Wang Zefeng
DOI: https://doi.org/10.3788/CJL202149.0615001
2022-01-01
Abstract:Objective Stimulated Raman scattering effect (SRS) is one of the major restrictions upon the further improvement of output power in fiber laser systems. So far, many methods have been explored for SRS suppression in fiber laser systems, such as enlarging the fiber effective mode area, the application of spectrally selective fibers, and using lumped spectral filters. The usage of a chirped and tilted fiber Bragg grating (CTFBG) has attracted much attention in recent years due to its all-fiber structure, flexible design, and good stability. A CTFBG can couple the forward core modes to the backward-propagating cladding mode. Based on the reasonable design of a CTFBG, the Stokes light of the core can be first coupled to the cladding and then leaks into the air, and thus the SRS filtering and suppression are realized. In 2017, the groups from National University of Defense and Technology have proposed and applied a CTFBG to suppress SRS for the first time. Up to now, a kW-level CTFBG with a low loss and a high rejection ratio has been realized and applied. However, it is still unable to meet the needs of a high-power fiber laser system in these years. Therefore, the development of CTFBGs with the ability to handle a higher power laser is an imminent necessity. Methods The CTFBG used in our experiment is fabricated with the ultraviolet laser phase mask method. The double cladding fiber with a core/cladding size of 25 mu m/400 mu m is utilized. The CTFBG had a filtering depth of >20 dB, a center wavelength of 1133.5 nm, and a 3 dB bandwidth of 7 nm (Fig. 1 ). The stability of the CTFBG is tested at the output of a master oscillator power amplification (MOPA) fiber laser system. Results and Discussions The CTFBG supports the maximum signal laser power of 4.35 kW with an insertion loss of less than 0 .3 dB. With the CTFBG working, a mere temperature rise of 7.5 degrees C upon the CTFBG device is recorded at the maximal output (Fig. 3(a)). The output power is very stable during a burn-in test of 10 min at the maximum output power (Fig. 3 (b)), which indicates the CTFBG can work stably and satisfy the application requirements in a high power fiber laser system. Conclusions This paper reports the CTFBG with the ability to support the highest power laser at home and abroad. The CTFBG on 25 mu m/400 mu m fiber supports the more than 4 kW laser power with an insertion loss of less than 0.3 dB and a high thermal handling capacity (similar to 1.72 degrees C /kW ). It is of great significance to promote the development of domestic high-power CTFBGs and expand their applications in high power fiber laser systems.