Abstract:In this work, a thin film transistor (TFT) with Zr-doped aluminum-zinc-tin oxide (Zr-AZTO) semiconductor as active layer was investigated. The Zr-AZTO thin films were co-sputtered by ZrO2 and AZTO targets (RF-Sputter) in Ar, and annealed at 350 degrees C in air atmosphere. With the discharge power of AZTO increasing from 100 W to 120 W, the content of Zr element decreases from 0.63 +/- 0.01 at.% to 0.34 +/- 0.01 at.%, and the oxygen vacancy decreases from (19.0 +/- 0.1)% to (17.3 +/- 0.8)%. The results of Zr-AZTO thin film show that the main factor is the co-sputter power of ZrO2 target. With the co-sputter power of ZrO2 increasing from 15 W to 45 W, the content of Zr element increases from 0.63 +/- 0.01 at.% to 2.79 +/- 0.01 at.%, the content of oxygen vacancy decreases from (19.0 +/- 0.1)% to (14.1 +/- 0.1)%, Eg increases from 2.76 eV to 2.86 eV, and the root mean square (RMS) roughness firstly decreases from 0.402 nm to 0.387 nm and then increases to 0.490 nm. The Micro Wave Photo Conductivity Decay (mu-PCD, LTA-1620SP) was used to measure the quality of Zr-AZTO thin film and the mean peak and D value decreases from 139.3 mV to 80.9 mV and from 1.54 to 0.77 as the co-sputter power of ZrO2 increases from 15 W to 45 W, which means it has highest localized states and defects in high ZrO2 co-sputter power. The devices prepared at 15 W (ZrO2)/100 W (AZTO) co-sputter show a best performance, with a mu(sat) of 8.0 +/- 0.6 cm(2)/(V.S), an Ion/loff of (2.01 +/- 0.34) x 10(6), and a SS of 0.18 +/- 0.03 V/dec. The device of Sample B has a 0.5 V negative shift under -20 V NBS and 9.6 V positive shift under 20 V PBS.

Evaluation of Nd–Al Doped Indium-Zinc Oxide Thin-Film Transistors by a Μ-Pcd Method

Zirconium-aluminum co-doping on solution-processed indium oxide thin film and deceives measured by a novel nondestructive method

The Performance Of Zr-Doped Al-Zn-Sn-O Thin Film Transistor Prepared By Co-Sputtering

The Effect of Zirconium Doping on Solution-Processed Indium Oxide Thin Films Measured by a Novel Nondestructive Testing Method (microwave Photoconductivity Decay)

Effect of Sputtering Oxygen Partial Pressure on the Praseodymium-Doped InZnO Thin Film Transistor Using Microwave Photoconductivity Decay Method

Effect of Source/drain Preparation on the Performance of Oxide Thin-Film Transistors

Alloy-Electrode-Assisted High-Performance Enhancement-Type Neodymium-Doped Indium-Zinc-Oxide Thin-Film Transistors on Polyimide Flexible Substrate

Amorphous Semi-Insulating Al-doped In2O3 Growth by Atomic Layer Deposition for Thin-Film Transistors

High-performance Al-Zn-O Thin-Film Transistors Sputtering at Different Power

Characteristic research of zinc oxide based thin film transistor by ALD technology

Atomic Layer Deposition Deposited Al-Doped ZnO Films for Transistor Application

Comparative Study of Aluminum-Doped Zinc Oxide, Gallium-Doped Zinc Oxide and Indium-Doped Tin Oxide Thin Films Deposited by Radio Frequency Magnetron Sputtering

Effect of Al Doping on Performance of ZnO Thin Film Transistors

Atomic-Layer-Deposition of Indium Oxide Nano-films for Thin-Film Transistors

Comparative Study of Indium Oxide Films for High‐Mobility TFTs: ALD, PLD and Solution Process

High-Performance Thin Film Transistor with an Neodymium-Doped Indium Zinc Oxide/Al2O3 Nanolaminate Structure Processed at Room Temperature

Preparation and Characterization of Molybdenum-Doped Indium-Zinc-Oxide Thin Film Transistors

Effect of Sc2O3 Passivation Layer on the Electrical Characteristics and Stability of InSnZnO Thin-Film Transistors

Amorphous NdIZO Thin Film Transistors with Contact-Resistance-Adjustable Cu S/D Electrodes

High-Performance and Flexible Neodymium- Doped Oxide Semiconductor Thin-Film Transistors with Copper Alloy Bottom-Gate Electrode

Effect of Sc 2 O 3 Passivation Layer on the Electrical Characteristics and Stability of InSnZnO Thin-Film Transistors