Abstract:Pipe cable is considered as an important form for underground transmission line. The maximum electrical current (ampacity) of power cable system mostly depends on the cable conductor temperature. Therefore, accurate calculation of temperature distribution in the power cable system is quite important to extract the cable ampacity. In the present paper, the fluid flow and heat transfer characteristics in the pipe cable with alternating current were numerically studied by using commercial code COMSOL MULTIPHYSICS based on finite element method (FEM). The cable core loss and eddy current loss in the cable were coupled for the heat transfer simulation, and the difference of heat transfer performances with pure natural convection model and radiation-convection model was compared and analysed in detail. Meanwhile, for the radiation-convection model, the effects caused by radiant emissivity of cable surface and pipe inner surface, as well as the cable location in the pipe, were also discussed. Firstly, it is revealed that the radiation and natural convection heat flux on the cable surface would be of the same order of magnitude, and the radiation heat transfer on the cable surface should not be ignored. Otherwise, the cable ampacity would be underestimated. Secondly, it is found that the overall heat transfer rate on the cable surface increases as the cable surface emissivity increases, and this is more remarkable to the upper cable. While the effect caused by the radiant emissivity on the pipe inner surface would be relatively small. Furthermore, it is demonstrated that, as cable location in the pipe falls, the natural convection heat transfer would be enhanced. These results would be meaningful for the ampacity prediction and optimum design for the pipe cable.

Numerical Study of Heat Transfer in Trefoil Buried Cable with Fluidized Thermal Backfill and Laying Parameter Optimization

Real‐time Calculation of Three Core Cable Conductor Temperature Based on Thermal Circuit Model with Thermal Resistance Correction

Numerical Study of Heat Transfer in Underground Power Cable System

Inversion of Soil Thermal Conductivity and Ampacity of the Buried High Voltage Power Cables

Numerical Study of Heat Transfer and Optimum Design for Trench Laying Cables with Ceramic Plates

NumericalStudyofHeatTransferandOptimumDesign Fortrench Laying Cables with Ceramic Plates

Heat Transfer Simulation and Temperature Rapid Prediction for Trench Laying Cable

Research on the Calculation Model for Transient Temperature Rise of Straight Buried Single-core Cable

Calculation of Ampacity of Double-loop XLPE Cables in Trenches Based on Multiphysics Simulation

Analysis of the eddy current loss and economy study in underground cable duct

Numerical Computation of Temperature Field and Ampacity of Underground Cables

Numerical Study of Convection and Radiation Heat Transfer in Pipe Cable

Research on Real-time Calculation Model for Transient Temperature Rise of Direct Buried Single-core Cable

Analysis of the Three-Dimensional Temperature Distribution and Ampacity of Forced Ventilation Multi-loop Cable Tunnel by Finite Element Method

Numerical Calculation of Real-Time Ampacity of High Voltage Power Cable Duct Laying Based on Environmental Information

Fast Calculation Method for Steady Temperature Rise of Buried Cable Group Based on Transfer Matrix

Research on the Improvement of Cable Ampacity in Dense Cable Trench

Cable heat dissipation considering air flow field,its influencing factors and economical efficiency

Calculation of Ampacity Reduction Factors for Buried Cables with Surroundings Based on FEM

The optimal diameter design of high-capacity transmission tunnels based on analysis of cable thermal effects

Simulation and Calculation of Temperature Field and Current-Carrying Capacity of Power Cables under Different Laying Methods