Abstract:This study conducted Detached-Eddy Simulations (DES) of actively controlled flow over a 0.35 m chord NACA0015 airfoil at an incidence angle of 11° and a chord Reynolds number of 1 million. The uncontrolled, natural flow were simulated by using DES-type methods, with a comparison of different underlying RANS models and subgrid-scale stress models in LES mode. Results from these computations were compared with experimental observations, enabling their reliable assessment through the detailed investigation of the Reynolds stresses as well as the separation and reattachment. It was found that among all five DES-type methods, only the Spalart–Allmaras-based Improved Delayed DES (IDDES-SA) captured the separation point as measured in the experiments. The classical vortex-shedding and the shear-layer flapping modes for airfoil flows with shallow separation were also extracted from the IDDES-SA results by using Dynamic Mode Decomposition. With better understanding of unsteady flow features, effective control practices were illustrated. The pulsed blowing actuation was adopted according to the experimental settings. The flow-field around jet orifices was resolved, instead of the use of actuation boundary conditions. It was found that for all actuation frequencies investigated in this article, the saturation of lift-to-drag ratio was yielded already at intermediate momentum coefficients, two-fifths of the actuation amplitude used in the experiment; the optimal actuation frequency was 0.6 among all cases, consistent with the dominant frequency of the baseline flow. The suppression of separation bubble led to a maximum lift-to-drag ratio enhancement of 194%, as well as a sharp decrease of all Reynolds stress components. To further reduce the strong unsteadiness introduced by excitation, a phase shift among jet orifices was applied and evaluated. The pulsed blowing with the jet orifices in an anti-phased manner was found to be very effective to damp the fluctuations of the lift around its mean value, though it led to a small decrease in mean lift.

Numerical Studies of Reverse Flows Controlled by Undulating Leading Edge

Numerical Studies of Undulation Control on Dynamic Stall for Reverse Flows

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

Numerical and Experimental Research of Flow Control on an NACA 0012 Airfoil by Local Vibration

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Numerical Simulation for Effects of Mach and Reynolds Number on Flow over Medium Radius Leading Edge Delta Wing

Reynolds Numbers and Leading-edge Bluntness Effects on Delta Wing

Numerical Studying the Dynamic Stall of Reverse Flow Past a Wing

Numerical Investigation of Active Flow Control on a Pitching NACA 0015 Airfoil Using Detached-eddy Simulation

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

Numerical Simulation of Transonic Shock-vortex Interaction Flow on Delta Wing Using DES

Numerical Investigation of Leading Edge Flap on Cranked Arrow Wing

Improved Delayed Detached Eddy Simulation of Super-Lift Flow of Co-Flow Jet Airfoil

Detached-Eddy Simulation of Three Airfoils with Different Stall Onset Mechanisms

Numerical Simulation of the Free Rolling Motion of a Delta Wing Configuration with Aileron Deflection

Detached-Eddy Simulations for Active Flow Control

The Influence of the Wavy Leading Edge on the Flow over an Airfoil

Numerical Investigation of Unsteady Vortex Breakdown Past 80°/65° Double-Delta Wing

Delayed Detached Eddy Simulation of the Wind Turbine Airfoil S809 for Angles of Attack Up to 90 Degrees

Numerical Study of Iced Airfoils with Horn Features Using Large-Eddy Simulation

A Comparative Study of DES Type Methods for Mild Flow Separation Prediction on a NACA0015 Airfoil