Abstract:A general two-dimensional (2D) theoretical approach capable of providing an explicit closed-form solution is developed for the calculation of elastic stresses in single-lap adhesive bonded joints, assuming linear distribution of a longitudinal normal stress in the joint thickness direction. By treating the adhesive layer in the same way as the adherends, the two-dimensional stress and strain distributions at any point, and the tensile force, shearing and bending moment at any cross section can be predicted accurately, in both the adhesive and adherends. This makes it possible for the subsequent failure analysis of the bonded joints to predict all the main modes such as adherend failure, cohesive failure and adhesive failure. The analysis is based on a two-dimensional elasticity theory that both includes the complete stress-strain and the complete strain-displacement relationships for the adhesive and adherends. Then, through the use of the displacement continuity conditions at the interfaces between the adhesive and adherends, four coupled, fifth-order ordinary differential equations with constant coefficients for the determination of the stresses are developed. The proposed method is capable of satisfying all the boundary stress conditions of the joint, including the stress-free surface condition at the ends of the bondline. The calibration of the new theoretical approach was verified by comparing it with the previously theoretical solutions, and the 2D geometrically nonlinear finite element models with the rotation and non-rotation boundary conditions. It is indicated that the present solution can provide a good prediction for the stress and strain distributions in the adhesive and adherends. A different approach is also established for determining bending moment factor of the short joints wherein the consideration of overall joint moment equilibrium is emphasized. It was shown that when the proposed bending moment factor is adopted instead of the original one, the classical solution by Goland and Reissner (1944) [4] might still remain applicable to the adherends and adhesive even with the parameter E3t1/(E1t3) 0.1.

Numerical Analysis of the Strength and Interfacial Properties of Adhesive Joints with Graded Adherends

Evaluation of the cracked lap shear test for mixed-mode fracture toughness estimation of adhesive joints

Viscoelastic Bilinear Cohesive Model and Parameter Identification for Failure Analysis of Adhesive Composite Joints

Numerical Simulation and Experimental Study of Tensile Shear Performance of Adhesively Bonded Single-Lap Joint

A Two-Dimensional Approach of Single-Lap Adhesive Bonded Joints

Interfacial shear stress analysis in single-lap adhesive joints with similar and dissimilar adherends under dynamic loading

Effects of adherend notching on the bonding performance of composite single-lap joints

Modelling of Deformation and Failure of Crash Toughened Adhesive Bonded Lap Shear Joints

Influence of Failure-Load Prediction in Composite Single-Lap Joints with Brittle and Ductile Adhesives Using Different Progressive-Damage Techniques

Parametric Investigation into the Shear Strength of Adhesively Bonded Single-Lap Joints

Numerical Investigation on the Loading-Delamination-unloading Behavior of Adhesive Joints

Enforcing of an theoretical solution of three adhesive joints into simplified finite element formulations for stiffness prediction

Determination of fracture toughness of an adhesive in civil engineering and interfacial damage analysis of carbon fiber reinforced polymer–steel structure bonded joints

Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints

Influences of adherent thickness, temperature and velocity on strength of adhesively-bonded single-lap joints

Finite Element Analysis of Crack Propagation in Adhesive Joints with Notched Adherends

Long‐term performance of single‐lap joints: Review, challenges and prospects in civil engineering

Experimental Investigation of the Mechanical Behavior of Aluminum Adhesive Joints under Mixed-Mode Loading Conditions

Numerical Analysis of Shear Stress on Adhesive Joint Between FRP and Steel Structure in Civil Engineering

Material and adhesive effect in adhesively-bonded composite stepped-lap joints

Computational Fracture Mechanics Assessment of Adhesive Joints