Abstract:The solar flux distribution on the receiver of a solar power tower is usually not uniform, which can cause a number of problems for the energy efficiency and system safety, particularly, the local hot spot and the thereby caused thermal stress and thermal deformation. Therefore, homogenization of the solar flux distribution is critical and important. The objective of the present study is to homogenize the solar flux distribution while keeping the optical loss (reflection loss) as low as possible through optimization of the distribution of the solar absorptive coating. An integrated approach coupling the Monte-Carlo ray tracing method and the Gebhart method is applied to simulate the process of the solar radiation transfer in the solar power system. The multi objective optimization of the distribution of solar absorptivity is performed by using the non-dominated sorting genetic algorithm. The following conclusions are drawn from the study. (1) The improvement of the uniformity of the distribution of solar flux can lead to more reflection loss due to the fact that more solar energy is distributed on the position with greater view factor to the aperture; (2) The Pareto optimal front obtained from the multi-objective optimization provides the trade-off between the non-uniformity of the solar flux distribution and the reflection loss. (3) The optimal solar absorptivity distribution provided by the Pareto optimal front can significantly flatten the solar flux distribution at a minimum cost of optical loss. (4) The optimal distribution of the solar absorptivity is approximately opposite to the distribution of solar flux projected onto the active surfaces from the heliostat fields.

Computational Optimal Design of Random Rough Surfaces in Thin-Film Solar Cells

A Stochastic Gradient Descent Method for Computational Design of Random Rough Surfaces in Solar Cells

Optimization-based Design of Surface Textures for Thin-Film Si Solar Cells.

Optimization-based design of surface textures for thin-film Si solar cells — Are conventional Lambertian models relevant?

Design and analysis of one-dimensional nanostructure on amorphous silicon solar cell for surface reflectance reduction

Design for optimal one-dimensional surface profile of EVA on solar cell modules

Efficient Optimal Design of Smooth Optical Freeform Surfaces Using Ray Targeting

Light Trapping Textures Designed by Electromagnetic Optimization for Sub-Wavelength Thick Solar Cells

Optimal Design of Thin-film Plasmonic Solar Cells using Differential Evolution Optimization Algorithms

Investigations Of Random Pyramid Texture On The Surface Of Single-Crystalline Silicon For Solar Cells

Optoelectronic optimization of graded-bandgap thin-film AlGaAs solar cells. Part II: optimal antireflection front-surface texturing

A Novel Method of Designing Random Rough Surface Considering Its Contact Force–Deformation Characteristic Requirement

Coupled Optoelectronic Simulation and Optimization of Thin-Film Photovoltaic Solar Cells

Optical Optimization of Ultra-Thin Crystalline Silicon Solar Cells by a Co-Simulation Approach of FEM and GA

Bio-inspired Design Strategy of Quasi-Random Structures for Optimal Light Control

Design and characterization of effective solar cells

Engineering disorder for light trapping in thin-film solar cells

Accurate Design of Solar Selective Absorber Based on Measured Optical Constants of Nano-thin Cr Film

Quasi-hemispherical pit array textured surface for increasing the efficiency of thin-film solar cells

Multi-objective Optimization of the Solar Absorptivity Distribution Inside a Cavity Solar Receiver for Solar Power Towers

Crystal Symmetry-Inspired Algorithm for Optimal Design of Contemporary Mono Passivated Emitter and Rear Cell Solar Photovoltaic Modules