Abstract:The two-parallel interleaved converters system is essentially a multilevel converter and introduces more vector redundancies than a single converter, leaving a large space for vector sequences optimization for the simultaneous optimization of crucial indicators. However, the vector redundancies have not been fully explored by previous studies to achieve multiple crucial indicators optimization. This article aims to obtain high efficiency and low torque ripples for the two-parallel interleaved converters-fed permanent-magnet synchronous motor (PMSM), which are dominantly affected by the switching loss, zero-sequence circulating current (ZSCC), and torque ripples. First, given the vector redundancies, this article explores the available vector sequences according to switching times, the minimal torque ripple, and ZSCC with a priority of the switching times. The resultant vector sequences split each 60° sector into eight subsectors, but each subsector has redundant vector sequences. Then, this article further quantitatively analyzes the torque ripple and ZSCC of the redundant vector sequences in the subsectors, based on which each subsector applies an optimal vector sequence. Despite the complexity of the divisions of the subsectors, this article proposes a simple carrier-based modulation scheme and the implementation of the proposed optimal vector sequences amounts to corresponding common-mode voltage (CMV) injections into the references, which only require a simple logic judgment. The theoretical analysis confirms that the proposed method yields smaller torque ripples, ZSCCs, and switching losses than existing pulsewidth modulation (PWM) schemes over the whole modulation indices. Finally, the experimental results further verify the theoretical analysis and the effectiveness of the proposed strategy.

Analysis and Reduction of Stator Copper Losses in Three-phase Four-switching Inverter-fed SPMSM Drives Using Space Vector Pulse-width Modulation

Investigation of Short Permanent Magnet and Stator Flux Bridge Effects on Cogging Torque Mitigation in FSPM Machines

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

A Hybrid PWM Scheme for Stator Loss Reduction of Two Parallel Interleaved Inverter-Fed PMSM Drive with a Minimized Switching Loss

Comprehensive Analysis and Reduction of Torque Ripples in Three-Phase Four-Switch Inverter-Fed PMSM Drives Using Space Vector Pulse-Width Modulation

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Hybrid Space Vector Modulation Strategy for Torque Ripple Minimization in Three-Phase Four-Switch Inverter-Fed PMSM Drives

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Hybrid Svpwm Technique for Reduced Torque Ripple in Permanent Magnet Synchronous Motor

Torque ripple analysis and reduction of permanent magnet synchronous motor

Torque Ripple Elimination Based on Inverter Voltage Drop Compensation for a Three-Phase Four-Switch Inverter-Fed PMSM Drive under Low Speeds

Improved Stator/Rotor-Pole Number Combinations for Torque Ripple Reduction in Doubly Salient PM Machines

Torque Ripple Reduction for a Four-switch Inverter Fed PMSM DTC System

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Quantitative Harmonics Performance Evaluation of High-Speed Permanent Magnet Synchronous Machine under Various Synchronous SVPWM Strategies

Torque Ripple Reduction of a Salient-Pole Permanent Magnet Synchronous Machine with an Advanced Step-Skewed Rotor Design.

An Improved Near-State Pulse-Width Modulation with Low Switching Loss for a Permanent Magnet Synchronous Machine Drive System

A Sensorless Drive Strategy for Open-End Winding PMSM with Common DC Voltage Based on Lower Switching Frequency

Evaluation of Three Improved Space-Vector-Modulation Strategies for the High-Speed Permanent Magnet Motor Fed by a SiC/Si Hybrid Inverter

Modified Synchronized SVPWM Strategies to Reduce CMV for Three-Phase VSIs at Low Switching Frequency

Optimal Vector Sequences for Simultaneous Reduction of the Switching Loss, Zero-Sequence Circulating Current, and Torque Ripple in Two Parallel Interleaved Inverter-Fed PMSM Drives