Abstract:The paper proposes a hybrid solution combining the LCC inverter with the continuously controlled IGCT‐based full‐bridge submodules (FBSMs) to solve the CF issues. The scheme can provide the LCC inverter with an additional commutation area, and compensate for the phase‐shift of the grid voltage under faults. With the decoupled control strategies of LCC and FBSMs, the proposed scheme can achieve better control effect and better CF resistance ability with less submodules compared with the existing controllable capacitor scheme. To solve the commutation failure (CF) issues in high voltage direct current (HVDC) transmission systems based on line commutated converter (LCC), this paper proposes a hybrid solution combining the LCC inverter with the continuously controlled IGCT‐based full‐bridge submodules (FBSMs). The scheme can provide the LCC inverter with an additional commutation area, and compensate for the phase‐shift of the grid voltage under faults. Therefore, it shows better CF resistance than the existing scheme. The characteristics of the proposed hybrid converter are modelled and analyzed in both normal and fault conditions. Then a decoupling control strategy is presented for it. With the ability to counteract negative‐sequence grid voltage, the strategy brings good voltage stability to the dc transmission. And when the grid fault occurs, it can switch to suppress CF by rapidly increasing the output voltage of the FBSMs and applying commutation failure prevention (CFPREV) control to the LCC. As a result, the CF issues can be maximally solved with a smaller number of FBSMs than the existing scheme. Simulations in PSCAD verify the effectiveness of the strategy. Furtherly, an experimental platform is built to show the capacity of the proposed scheme to solve the CF issues.

Fault-Tolerant Control Of Cps-Pwm-Based Cascaded Multilevel Inverter With Faulty Units

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

A Fault-Tolerant Control Strategy for Three-Level Grid-Connected NPC Inverters after Single-Arm Failure with Optimized SVPWM

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

The Control Strategy Of Cascaded Multi-Cell Medium-Voltage Wind Power Converter Under Fault Condition

Control method for cascaded H-bridge multilevel inverter with faulty power cells

Control Strategies for LCC-MMC Hybrid DC System Connected to Passive Networks

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

A novel fault-tolerant Shunt Active Power Filter and its control strategy

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM

A Novel Method For Improving The Fault Tolerance Of Transformerless Cascade Pwm Statcom

Control Strategies for A New Hybrid Modular Multilevel Converter under Fault Conditions

A Fault-Tolerated Control Strategy for Sub-Module Faults of Modular Multilevel Converters

A Novel Fault-Tolerant Control of Modular Multilevel Converter under Sub-Module Faults Based on Phase Disposition PWM

Reconfiguration of Carrier-Based Modulation Strategy for Fault Tolerant Multilevel Inverters

A modified control strategy for LCC with IGCT‐based full‐bridge submodules to solve the commutation failure issues

A Fault Tolerant Control Strategy for the Delta-Connected Cascaded Converter