Heat Transfer from a Hot Steel Plate Impinged by Air-atomized Water Jet and Impinging Water Jet

Qian Xie,Zhenyi Huang,Qingyu Hou,Long Zhang,Jiajia Cai

DOI: https://doi.org/10.2355/isijinternational.isijint-2018-266

2019-01-01

ISIJ International

Abstract:The hot rolled steel plate has been widely used in construction engineering, machinery manufacturing, container manufacturing, shipbuilding and many other fields. One of its main manufacture processes is the plate cooling to a targeted temperature at a given cooling rate. The formation and distribution of microstructure in the plate (cools down from above 750°C high-temperature) are highly dependent on the cooling rate. Therefore, the cooling process is critical to control the plate mechanical properties. However, there are still many problems in the cooling process, such as the low cooling capacity, poor cooling uniformity, complicated radiation model,1) and low cooling efficiency. Up to date, laminar jet cooling is the most prevalent cooling form in steel industries. The main disadvantage of jet cooling is the accumulated water on the plate, thus most of the cooling water slides and falls off the plate instead of directly impinging on the plate because of the Leidenfrost phenomenon.2–4) Due to the strong boiling intensity under high thermal gradient, a layer of vapor filmforms between the surface and cooling water and then decreases the heat transfer rate by degrading the probability of solid-liquid contact. Many researchers have worked on the jet impingement cooling. Leocadio5) reported the cooling process of a hot plate by vertical water jet with different initial temperatures. Their results demonstrated the shape and magnitude of the boiling curves were sharper accordingly with the increase Heat Transfer from a Hot Steel Plate Impinged by Air-atomized Water Jet and Impinging Water Jet