Abstract:Jet impingement cooling is widely used in many industrial applications due to its high heat transfer capability and is an option for advanced high power density systems. Jet impingement cooling with supercritical pressure fluids could have much larger heat transfer rates combining with the large fluid specific heat near the pseudocritical point. However, the knowledge of its flow and heat transfer characteristics is limited. In this study, the flow and the local and average heat transfer characteristics of jet impingement cooling with supercritical pressure fluids were studied experimentally with carbon dioxide first. An integrated thermal sensor chip that provided heating and temperature measurements was manufactured using micro-electro-mechanical systems (MEMS) techniques with a low thermal conductivity substrate as the impingement cooled plate. The experiment system pressure was 7.85 MPa, which is higher than the critical pressure of carbon dioxide of 7.38 MPa. The mass flow rate ranged from 8.34 to 22.36 kg/h and the Reynolds number ranged from 19,000 to 68,000. The heat flux ranged from 0.02 to 0.22 MW/m(2). The nozzle inlet temperature ranged from lower to higher than the pseudocritical temperature. Dramatic variations of the density at supercritical pressures near the heating chip were observed with increasing heat flux in the strong reflection and refraction of the backlight that disappeared at inlet temperatures higher than the pseudocritical temperature. The local heat transfer coefficient near the stagnation point increased with increasing heat flux while those far from the stagnation point increased to a maximum with increasing heat flux and then decreased due to the nonuniformity of jet impingement cooling. The heat transfer is higher at inlet temperatures lower than the pseudocritical temperature and the surface temperature is slightly higher than the pseudocritical temperature due to the dramatic changes in the fluid thermo-physical properties at supercritical pressures.

Heat transfer characteristics of water jet impingement on high-temperature steel plate by angular nozzle

Experimental study on the heat transfer of moving double jet impingement during steel quenching

Heat Transfer from a Hot Steel Plate Impinged by Air-atomized Water Jet and Impinging Water Jet

Surface heat flux of upward circular water jet impingement on a moving hot steel sheet

Experimental study on heat transfer of jet impingement with a moving nozzle

Effect of the Nozzle Geometry on Flow Field and Heat Transfer in Annular Jet Impingement

Comparative Study Of Impinging Jet Array Heat Transfer On A Flat Plate Cooled By Superheated Steam And Air

Numerical simulation of single-jet impact cooling and double-jet impact cooling of hot-rolled L-shaped steel based on multiphase flow model

Numerical Investigation of Jet Impingement Cooling of a Low Thermal Conductivity Plate by Supercritical Pressure Carbon Dioxide

Study of the Effect of Initial Plate Temperature in Jet Impingement Cooling Process

Numerical study on jet impingement boiling cooling of nose cone

Numerical simulation and experimental study of strip steel jet cooling

Numerical Study on the Heat Transfer of Confined Air-Jet Quenching of Steel Sheets

On heat transfer and flow characteristics of jets impinging onto a concave surface with varying jet arrangements

Experimental Research on the Cooling Characteristics by Swirling Impinging Jet from a Nozzle with Internal Thread

Numerical Simulation of the Flow and Heat Transfer Characteristics of Sweeping and Direct Jets on a Flat Plate with Film Holes

Experimental and Numerical Study on Heat Transfer with Impinging Circular Jet on a Convex Hemispherical Surface

Flow behavior and heat transfer characteristics of liquid film on vertical hot surface by inclined jet impingement

An Experimental Study of Heat Transfer With an Impinging Circular Water Jet

Heat Transfer Characteristics with Impinging Circular Jet at Curved Surface

Numerical Study On Flow And Heat Transfer Characteristics Of Jet Impingement