Abstract:High-speed injection of solid fuel was first proposed in 1954 as a possible solution to the problem of transporting fresh fuel across the confining magnetic fields into the plasma of a fusion reactor. While it took a few decades, the use of cryogenic pellets (typically H2 and D2) on fusion experiments became common place; most tokamaks and stellarators are now equipped with a pellet injector(s). These devices operate at low temperatures (~10 to 20 K) and most often use a simple light gas gun to accelerate macroscopic-size pellets (~0.4- to 6-mm diameter) to speeds of ~100 to 1000 m/s. Before the advantages of pellet injection from the magnetic high-field side (HFS) of a tokamak were recognized in 1997, development focused on increasing the pellet speed to achieve deeper plasma penetration and higher fueling efficiency. The HFS injection technique typically dictates slower pellets (~100 to 300 m/s) to survive transport through the curved guide tubes that route the pellets to the plasma from the inside wall of the device. Two other key operating parameters for plasma fueling are the pellet-injection repetition rate and time duration—a single pellet is adequate for some experiments and a steady-state injection rate of up to ~50 Hz is appropriate for others. In addition to plasma fueling, cryogenic pellets have often been used for particle transport and impurity studies in fusion experiments (most often with neon pellets). During the past two decades, a few new applications for cryogenic pellets have been developed and used successfully in plasma experiments: (1) one for edge-localized mode mitigation, (2) one for plasma disruption mitigation (requires large pellets that are shattered before injection into the plasma), and (3) another in which pure argon pellets are used to trigger runaway electrons in the plasma for scientific studies. In this paper, a brief history and the key developments in this technology during the past 25 years are presented and discussed.

Preliminary Experimental Results of Pellet Injection on the HL-2A Tokamak

Pellet Enhanced Performance on the Hl-2a Tokamak

Observation of MBI and pellet injection penetration on HL-2A

Plasma behaviour with hydrogen supersonic molecular beam and cluster jet injection in the HL-2A tokamak

Recent Experiment Results During Electron Cyclotron Heating On Hl-2a

Present Progress of Plasma Transport Study on HL-2A

Overview of Hl-2a Experiment Results

1 EX / P 3-21 Plasma Behavior with Hydrogen Supersonic Molecular Beam and Cluster Jet Injection in the HL-2 A Tokamak

Experimental study of injection depth and fuelling effects during supersonic molecular beam injection on the HL-2A tokamak

OV / 4-5 1 Overview of Experimental Results on the HL-2 A Tokamak

Overview of Experimental Results on the HL-2A Tokamak

Observation of MBI and Pellet Injection Penetration on HL-2 A

Preliminary Experimental Results of Shattered Pellet Injection on the HL-2A Tokamak

New Experimental Results Obtained using Microwave Reflectometry in HL-2 A Tokamak

Impact of Impurity Mixture Gas Seeded by Supersonic Molecular Beam Injection on Edge-Localized Modes in the HL-2A Tokamak

The Development of Shattered Pellet Injector on HL-2A

Simulation study of deuterium pellet ablation and deposition in the EAST tokamak with HPI2 code

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Pellet-Injector Technology—Brief History and Key Developments in the Last 25 Years

Multi-pellet injection into the NBI-heated phase of TJ-II plasmas

High performance experiments on high pressure supersonic molecular beam injection in the HL-1M tokamak