Abstract:Weakly agglomerated nanocrystalline scandia doped tin oxide powders with high surface area (170−220 m2/g) and uniform size (3−4 nm) were synthesized for the first time by a two-step hydrothermal process in the presence of urea, followed by the calcination between 500 and 1200 °C. The structure and texture of the binary oxide system were characterized by thermogravimetry and differential thermal analysis, Brunauer−Emmett−Teller-specific surface area analysis, transmission electron microscopy, X-ray diffraction, Raman spectroscopy, and X-ray photoelectron spectroscopy. A metastable scandium tin oxide solid solution in tetragonal structure was formed for the scandia content lower than 6 mol % as the samples were calcined at 800 °C, and the excess Sc atoms were dispersed at the surface of the crystallites above this limit. The solid solution was metastable, so scandium migrated toward the surface region of the crystallites and produced a second phase of Sc4Sn3O12 during calcining at high temperatures over 1000−1200 °C. In the case of the samples with higher dopant concentration (>15 mol %), the calcination at the temperature between 500 and 800 °C caused the precipitation of Sc2O3, and the calcination over 1000−1200 °C led to the formation of more Sc4Sn3O12. Textural analysis showed that doping an appropriate amount of Sc2O3 into nanosized SnO2 could effectively inhibit the grain growth and stabilize the surface area against high-temperature calcinations below 1000 °C. CO gas-sensing property measurements revealed that the dispersion of Sc at the surfaces of the SnO2 nanocrystallites could improve the CO sensitivity significantly, and the pellet sample with scandia content of 10 mol % sintered at 800 °C showed the best CO gas-sensing property in the operation temperature range of 300−400 °C. On the basis of the structural and textural analysis, the correlation between the structure/texture and the sensitivity to CO for the as-calcined (SnO2)1-x(Sc2O3)x nanocrystallites has been established and explained.

Characterization of Scrutinyite SnO2 and Investigation of the Transformation with 119sn NMR and Complex Impedance Method

Characterization of Individual SnO2 Nanobelts with STM

Identification of Different Tin Species in SnO2 Nanosheets with 119sn Solid-State NMR Spectroscopy

Static and Dynamic Disorder in Metastable Phases of Tin Oxide

Microstructural, optical, and morphological investigations of SnO2 nanomaterials grown by microwave assisted sol gel method

Atomic Structure and Properties of SnO2 (100) and (101) Surfaces and (301) Steps in the (100) Surface

Multiform Structures of SnO2 Nanobelts

Crystal and electronic structure engineering of tin monoxide by external pressure

First-Principles Investigations on Electronic Properties of Rutile TiO2:F and SnO2:F

Structural and magnetic properties of tin oxide (SnO 2 ) nanoparticles for testing spintronic device applications

A study on phase transformation of SnOx thin films prepared by reactive magnetron sputtering

Preparation and Characterization of SnO2 Thin Film by MOD Method

Synthesis and characterization of SnO2 nanorods

Investigation of structural and photoluminescence properties of nanocrystalline tin oxide thin films grown by ultrasonic spray pyrolysis method

Gas Sensing Property and Microstructure of SnO2 Nanocrystalline Prepared by Solid State Reaction—thermal Oxidation

Growth of Novel Tin Oxide Nanocrystals under Different Ph: Structure Evolution, Broad Spectrum Response and Photocatalytic Activity

In Situ Resolving the Atomic Reconstruction of SnO 2 (110) Surface

Synthesis, Structure, Texture, and CO Sensing Behavior of Nanocrystalline Tin Oxide Doped with Scandia

Structure and Positron Annihilation Spectra of Tin Incorporated in Mesoporous Molecular Sieves

Annealing Atmospheres Effects on the Microstructure and Photoluminescence of Co-doped SnO2 Nanoparticles

SnO2 doping effects on the phase constitution and microwave dielectric properties of a Co0.5Ti0.5NbO4 system